Disclaimer
How to change front wheel bearing on SKODA SUPERB (3V3) – replacement guide
downloads:
14
Views:
290
Important!
This replacement procedure can be used for:
SKODA SUPERB (3V3) 2.0 TSI 4x4, SKODA SUPERB (3V3) 2.0 TDI 4x4, SKODA SUPERB (3V3) 1.4 TSI 4x4, SKODA SUPERB (3V3) 2.0 TDI 4x4, SKODA SUPERB (3V3) 2.0 TSI 4x4 … View more
The steps may slightly vary depending on the car design.
SKODA SUPERB (3V3) 2.0 TSI 4x4, SKODA SUPERB (3V3) 2.0 TDI 4x4, SKODA SUPERB (3V3) 1.4 TSI 4x4, SKODA SUPERB (3V3) 2.0 TDI 4x4, SKODA SUPERB (3V3) 2.0 TSI 4x4 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Wheel Bearing for SUPERB (3V3) and other SKODA models
Alternative products

Wire brush
WD-40 spray
Copper grease
Drive socket # 15
Drive socket # 21
12-point socket # 24
XZN socket bit # 12
Torx bit T30
Wheel impact socket #17
Ratchet wrench
Torque wrench
Tap wrench
Crow bar
Rubber mallet
Hydraulic transmission jack
Wheel chock
Replacement: wheel bearing – SKODA SUPERB (3V3). AUTODOC experts recommend:
- The wheel hub bearing replacement procedure is identical for both wheels on the same axle.
- Please note: all work on the car – SKODA SUPERB (3V3) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1
Secure the wheels with chocks. - Step 2
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 3
Raise the front of the car and secure on supports. - Step 4
Unscrew the wheel bolts.Replacement: wheel bearing – SKODA SUPERB (3V3). AUTODOC recommends:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 5
Remove the wheel. - Step 6
Remove the hub bearing protection cap. - Step 7
Install the wheel.AUTODOC recommends:Important! Hold the wheel while screwing in the fastening bolts. SKODA SUPERB (3V3) - Step 8
Screw in the wheel bolts. Use wheel impact socket #17. - Step 9
Loosen the wheel hub bolt. Use drive 12-point socket #24. Use a tap wrench. - Step 10
Unscrew the wheel bolts.Replacement: wheel bearing – SKODA SUPERB (3V3). Tip:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 11
Remove the wheel. - Step 12
Spread the brake pads. Use a crowbar. - Step 13
Unscrew the caliper bracket fastening. Use a drive socket #21. Use a ratchet wrench. Use a tap wrench. - Step 14
Remove the brake caliper together with its bracket.Replacement: wheel bearing – SKODA SUPERB (3V3). Professionals recommend:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. - Step 15
Unscrew the brake disc fastening. Use Torx T30. Use a ratchet wrench. - Step 16
Remove the brake disc. - Step 17
Unscrew the wheel hub axle nut. Use drive 12-point socket #24. - Step 18
Clean the hub. Use a wire brush. Use WD-40 spray. - Step 19
Remove the drive shaft from the wheel hub.Replacement: wheel bearing – SKODA SUPERB (3V3). Tip from AUTODOC experts:Make sure that the drive shaft is not unloaded (when the car is jacked). - Step 20
Unscrew the fastener connecting the ball joint to the suspension control arm. Use a drive socket #15. Use a ratchet wrench. - Step 21
Disconnect the lower arm from the steering knuckle. Use a crowbar. - Step 22
Prop up the steering knuckle. Use a hydraulic transmission jack. - Step 23
Unscrew the wheel hub axle nut. Use XZN #12. Use a ratchet wrench. Use a tap wrench. - Step 24
Remove the hub and the bearing together, since they are a sealed unit. Use a crowbar.Replacement: wheel bearing – SKODA SUPERB (3V3). Tip from AUTODOC:If necessary, use a rubber mallet. - Step 25
Clean the hub bearing mounting seat. Use a wire brush. Use WD-40 spray. - Step 26
Install the new wheel hub with a bearing.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the SKODA Superb III Hatchback (3V3) model
Popular maintenance tutorials for Skoda Superb 3V3
Complete guides for changing the Wheel bearings on different SKODA SUPERB models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your SKODA SUPERB (3V3)
View more
Top 5 reasons why your car squeals | AUTODOC Tips
Unveiling the secrets: Detecting vacuum leaks with a Smoke Machine | AUTODOC
Deep interior cleaning | Car transformation by detailing
#DIY Tips for Fixing Your Car's Air Conditioning Issues | Don't Wait for Costly Repairs!
Most commonly replaced car parts on SKODA SUPERB
Time to replace parts? Get even better deals in our Shop app.

SCAN ME




































