Disclaimer
How to change front strut mount on VAUXHALL Astra Mk IV (G) Coupe (T98) – replacement guide
downloads:
0
Views:
5
Important!
This replacement procedure can be used for:
VAUXHALL Astra Mk IV (G) Coupe (T98) 1.8 16V, VAUXHALL Astra Mk IV (G) Coupe (T98) 2.0 16V Turbo, VAUXHALL Astra Mk IV (G) Coupe (T98) 2.2 16V, VAUXHALL Astra Mk IV (G) Coupe (T98) 1.8 16V, VAUXHALL Astra Mk IV (G) Coupe (T98) 1.6 16V … View more
The steps may slightly vary depending on the car design.
VAUXHALL Astra Mk IV (G) Coupe (T98) 1.8 16V, VAUXHALL Astra Mk IV (G) Coupe (T98) 2.0 16V Turbo, VAUXHALL Astra Mk IV (G) Coupe (T98) 2.2 16V, VAUXHALL Astra Mk IV (G) Coupe (T98) 1.8 16V, VAUXHALL Astra Mk IV (G) Coupe (T98) 1.6 16V … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Strut Mount for Astra Mk IV (G) Coupe (T98) and other VAUXHALL models
Alternative products

Wire brush
WD-40 spray
Copper grease
Drive socket # 9
Drive socket # 17
Drive socket # 18
Combination spanner #17
Combination spanner #18
Combination spanner #19
Wheel impact socket #17
Ratchet wrench
Torque wrench
Flat screwdriver
Tap wrench
Crow bar
Hydraulic transmission jack
Hydraulic strut spring compressor
Fender cover
Wheel chock
Replacement: strut mount – VAUXHALL ASTRA Mk IV (G) Coupe (F67). Professionals recommend:
- All mounts of the front shock struts should be replaced simultaneously.
- The replacement procedure is identical for the mounts of the left and right shock struts of the front suspension.
- Be sure to replace all self-locking nuts and bolts during installation.
- All work should be done with the engine stopped.
Replacement: strut mount – VAUXHALL ASTRA Mk IV (G) Coupe (F67). Take the following steps:
- Step 1Open the bonnet.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3Remove the shock strut mount cap. Use a flat screwdriver.Step 4Treat the shock strut rod. Use a wire brush. Use WD-40 spray.Step 5
Unscrew the shock absorber mount fastening. Use a combination spanner #17. Use a drive socket #9. Use a ratchet wrench. - Step 6
Secure the wheels with chocks. - Step 7
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 8Raise the front of the car and secure on supports.Step 9
Unscrew the wheel bolts.Replacement: strut mount – VAUXHALL ASTRA Mk IV (G) Coupe (F67). AUTODOC recommends:To avoid injury, hold up the wheel when unscrewing the bolts. - Step 10
Remove the wheel. - Step 11
Clean the fasteners connecting the stabiliser link to the shock strut, and those connecting the shock strut to the steering knuckle. Use a wire brush. Use WD-40 spray. - Step 12
Unscrew the nut and remove the stabilizer rod from the shock strut. Use a combination spanner #19. Use a drive socket #18. Use a ratchet wrench. - Step 13
Unscrew the lower fastener connecting the shock strut to the steering knuckle. Use a combination spanner #18. Use a drive socket #18. Use a tap wrench. - Step 14
Prop up the steering knuckle. Use a hydraulic transmission jack. - Step 15
Remove the fastener attaching the brake hose to the shock strut. - Step 16
Disconnect the brake hose holder from the shock absorber strut. Use a flat screwdriver. - Step 17
Disconnect the steering knuckle from the shock absorber strut. Use a crowbar. - Step 18
Unscrew the upper fastening of the shock absorber strut. Use a combination spanner #17. Use a drive socket #9.AUTODOC recommends:Important! Hold the suspension strut while unscrewing the fastening bolts. VAUXHALL ASTRA Mk IV (G) Coupe (F67) - Step 19
Remove the suspension strut. - Step 20
Set the shock absorber strut on the spring compressor tool.Replacement: strut mount – VAUXHALL ASTRA Mk IV (G) Coupe (F67). AUTODOC experts recommend:Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles. - Step 21
Compress the spring. - Step 22
Remove the strut piston rod nut. Use a combination spanner #19. Use a drive socket #9. - Step 23
Remove the shock absorber mount, boot and bump stop. Use a crowbar. - Step 24
Install the new mount, boot, and bump stop on the shock absorber. - Step 25
Tighten the shock strut piston rod nut. Use a combination spanner #19. Use a drive socket #9. Use a torque wrench. Tighten it to 50 Nm torque.Replacement: strut mount – VAUXHALL ASTRA Mk IV (G) Coupe (F67). Tip:Check to make sure the spring is positioned correctly. Avoid its misalignment. Important! Be sure to use new fasteners. - Step 26
Decompress the spring. - Step 27
Remove the assembled shock strut.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VAUXHALL Astra Mk4 (G) Coupe (T98) model
Popular maintenance tutorials for VAUXHALL ASTRA Mk IV (G) Coupe (F67)
Complete guides for changing the Strut mount on different VAUXHALL ASTRA models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VAUXHALL Astra Mk IV (G) Coupe (T98)
View more
7 signs of faulty fuel injectors | AUTODOC tips
DIY manual gearbox restoration | Drivetrain restoration – Part 3
Reviving Your Car: How to Start After Extended Idle Time | AUTODOC Tips
5 easy car repairs you can do without a garage visit
Most commonly replaced car parts on VAUXHALL ASTRA
Time to replace parts? Get even better deals in our Shop app.

SCAN ME




































