Important!

This replacement procedure can be used for:
SKODA SUPERB (3U4) 1.8 T, SKODA SUPERB (3U4) 2.0, SKODA SUPERB (3U4) 1.9 TDI, SKODA SUPERB (3U4) 1.9 TDI, SKODA SUPERB (3U4) 1.9 TDI, SKODA SUPERB (3U4) 1.9 TDI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Coil spring

Replacement: coil springs – SKODA SUPERB (3U4). Tools you might need:

                      Wire brush
                    
                      WD-40 spray
                    
                      Brake cleaner
                    
                      Copper grease
                    
                      HEX bit No.H6.
                    
                      Drive socket # 13
                    
                      Drive socket # 17
                    
                      Drive socket # 18
                    
                      Drive socket # 19
                    
                      Combination spanner #17
                    
                      Combination spanner #18
                    
                      Wheel impact socket #17
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Hammer
                    
                      Pin punch
                    
                      Flat chisel
                    
                      Rubber mallet
                    
                      Flat Screwdriver
                    
                      Pliers 
                    
                      Hydraulic transmission jack
                    
                      Hydraulic strut spring compressor
                    
                      Fender cover
                    
                      Wheel chock

Buy tools

Replacement: coil springs – SKODA SUPERB (3U4). AUTODOC recommends:

Both coil springs of the front suspension should be replaced simultaneously.
The replacement procedure is identical for the left and right coil springs of the front suspension.
All work should be done with the engine stopped.

Replacement: coil springs – SKODA SUPERB (3U4). Take the following steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 3

Raise the front of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

Replacement: coil springs – SKODA SUPERB (3U4). Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 5

Remove the wheel.
Step 6

Clean the fastening bolt that connects the shock absorber fork with the lower control arm. Use a wire brush. Use WD-40 spray.
Step 7

Unscrew the fastening bolt that connects the shock absorber fork with the lower control arm. Use a combination spanner #18. Use a drive socket #18. Use a ratchet wrench.
Step 8

Remove the fastening bolt.
Step 9

Unscrew the upper arm fastenings. Use a combination spanner #17. Use a drive socket #17. Use a ratchet wrench.
Step 10

Remove the fastening bolt. Use a pin punch. Use a hammer.
Step 11

Remove the control arms. Use a flat metal-working chisel. Use a hammer.
Step 12

Detach the bottom part of the shock strut.
Step 13

Lower the car.

Step 14

Open the bonnet.

Step 15

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 16

Remove the protective caps out of the shock absorber mounting fastener. Use a flat screwdriver. Use pliers.
Step 17

Unscrew the upper fasteners of the shock strut. Use a drive socket #13. Use a ratchet wrench.

Replacement: coil springs – SKODA SUPERB (3U4). AUTODOC experts recommend:
To avoid injuries, hold the shock strut when undoing the fastening bolts.
Step 18

Remove the suspension strut.
Step 19

Set the shock absorber strut on the spring compressor tool.

Replacement: coil springs – SKODA SUPERB (3U4). Professionals recommend:
Note that when using a spring compressor, spring coils need to be securely gripped, compressing the spring on the opposite sides.Ensure the correct position of the spring in the retainer.Make sure that the spring coils tightly entered the lock handles.
Step 20

Compress the spring.

Step 21

Treat the shock strut rod. Use a wire brush. Use WD-40 spray.
Step 22

Remove the strut piston rod nut. Use a drive socket #19. Use a ratchet wrench.
Step 23

Remove the top strut mount.
Step 24

Release the coil spring.

Step 25

Remove the shock absorber dust cap and the bump stop.
Step 26

Remove the spring.

AUTODOC recommends:
Replacement: coil springs – SKODA SUPERB (3U4). Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.
Step 27

Install the spring on the shock absorber.
Step 28

Install the dust boot and bump stop on the shock absorber.

Step 29

Compress the spring.
Step 30

Install the upper strut mount and the strut mount bearing.
Step 31

Tighten the shock strut piston rod nut. Use a drive socket #19. Use HEX No.H6. Use a ratchet wrench. Use a torque wrench. Tighten it to 50 Nm torque.

Replacement: coil springs – SKODA SUPERB (3U4). AUTODOC experts recommend:
Check to make sure the spring is positioned correctly. Avoid its misalignment.
Step 32

Decompress the spring.

Step 33

Remove the assembled shock strut.
Step 34

Install the shock strut into the wheel arch.
Step 35

Secure the upper fasteners of the shock strut.

AUTODOC recommends:
Important! Hold the suspension strut while screwing in the fastening bolts. SKODA SUPERB (3U4)
Step 36

Tighten the upper fasteners of the shock strut. Use a drive socket #13. Use a torque wrench. Tighten it to 20 Nm torque.
Step 37

Put the protective caps onto the shock absorber mounting fastener. Use a flat screwdriver.
Step 38

Remove the fender protection cover.

Step 39

Close the hood.

Step 40

Raise the front of the car and secure on supports.

Step 41

Prop up the steering knuckle. Use a hydraulic transmission jack.
Step 42

Attach the bottom part of the shock strut.
Step 43

Install the fastening bolt. Use a pin punch. Use a hammer.
Step 44

Install the control arms Use a rubber mallet.
Step 45

Install the fastening bolt. Use a pin punch. Use a hammer.
Step 46

Tighten the upper arm fastenings. Use a combination spanner #17. Use a drive socket #17. Use a torque wrench. Tighten it to 40 Nm torque.
Step 47

Raise the hydraulic transmission jack by 10-15 cm.
Step 48

Tighten the fastening bolt that connects the shock absorber fork to the lower control arm. Use a combination spanner #18. Use a drive socket #18. Use a torque wrench. Tighten it to 90 Nm torque.
Step 49

Remove the support from under the steering knuckle.

Replacement: coil springs – SKODA SUPERB (3U4). Tip from AUTODOC experts:
Lower the hydraulic transmission jack smoothly, without jerks, to avoid damaging assemblies and mechanisms.
Step 50

Treat the shock strut fasteners. Use copper grease.
Step 51

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 52

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: coil springs – SKODA SUPERB (3U4). After applying the spray, wait a few minutes.
Step 53

Install the wheel.

Replacement: coil springs – SKODA SUPERB (3U4). Tip:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 54

Screw in the wheel bolts. Use wheel impact socket #17.
Step 55

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #17. Use a torque wrench. Tighten it to 120 nm torque.
Step 56

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the SKODA Superb I Saloon (3U4) model

Skoda Superb 3u tyre size

How to change rear shock absorbers on SKODA SUPERB (3U4) – replacement guide

Free download PDF
1.92 MB
How to change front suspension strut on SKODA SUPERB (3U4) – replacement guide

Free download PDF
3.85 MB
How to change front brake pads on SKODA SUPERB (3U4) – replacement guide

Free download PDF
1.59 MB
How to change rear brake pads on SKODA Superb I Saloon (3U4) – replacement guide

Free download PDF
1.44 MB
How to change rear brake discs on SKODA SUPERB (3U4) – replacement guide

Free download PDF
1.66 MB
How to change front brake discs on SKODA SUPERB (3U4) – replacement guide

Free download PDF
2.03 MB

How to change front coil springs on SKODA SUPERB Estate (3V5) – replacement guide

Free download PDF
3.89 MB
How to change front coil springs on SKODA SUPERB (3V3) – replacement guide

Free download PDF
3.9 MB
How to change rear coil springs on SKODA Superb II Estate (3T5) – replacement guide

Free download PDF
2.06 MB
How to change front coil springs on SKODA SUPERB Estate (3T5) – replacement guide

Free download PDF
3.83 MB
How to change front coil springs on SKODA SUPERB (3T4) – replacement guide

Free download PDF
4.08 MB
How to change coil springs on a car – replacement tutorial

Universal

Free download PDF
1.91 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Stop Rust Before It Starts: Top 5 Tips for Car Body Protection | AUTODOC Insights

7K views

Published on: 27/07/2023
Top 5 car noises you shouldn't ignore

7K views

Published on: 10/04/2025
How to clean the engine bay perfectly

10K views

Published on: 13/11/2025
Fuse Replacement Made Simple: Step-by-Step Guide | AUTODOC

3K views

Published on: 15/08/2020