Recommended replacement interval for the part category Oil filter : 1 year / 30000 km

Important!

This replacement procedure can be used for:
VAUXHALL Vectra (B) CC (J96) 2.0 Di 16V (F68), VAUXHALL Vectra (B) CC (J96) 2.0 DTi 16V (F68), VAUXHALL Vectra (B) CC (J96) 2.2 DTI 16V (F68) … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Oil Filter for Vectra (B) CC (J96) and other VAUXHALL models

Oil filter

        Oil filter for Vectra Mk1 (B) CC (J96) Diesel (82 hp)
      
        Oil filter for Vectra Mk1 (B) CC (J96) Diesel (101 hp)
      
        Oil filter for Vectra Mk1 (B) CC (J96) Diesel (125 hp)

Replacement: engine oil and filter – VAUXHALL VECTRA (B) Hatchback. Tools you'll need:

                        Wire brush
                      
                        All-purpose cleaning spray
                      
                        Drive socket # 36 
                      
                        Torx bit T45
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Oil drain pan
                      
                        Funnel
                      
                        Flat Screwdriver
                      
                        Fender cover

Buy tools

Replacement: engine oil and filter – VAUXHALL VECTRA (B) Hatchback. AUTODOC experts recommend:

Replace the oil filter every time when changing motor oil.
Wear gloves to prevent contact with hot liquid.
All work should be done with the engine stopped.

Replacement: engine oil and filter – VAUXHALL VECTRA (B) Hatchback. Recommended sequence of steps:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Unscrew the oil filler plug.
Step 4

Lift the car using a jack or place it over an inspection pit.

Replacement: engine oil and filter – VAUXHALL VECTRA (B) Hatchback. Tip:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All work should be done with the engine stopped.
Step 5

Put a waste oil container with at least 6 l capacity under the drainage hole.
Step 6

Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
Step 7

Unscrew the drain plug. Use Torx T45. Use a ratchet wrench.
Step 8

Drain the used oil.

Replacement: engine oil and filter – VAUXHALL VECTRA (B) Hatchback. AUTODOC recommends:
Caution! The oil may be hot.
Step 9

Clean the oil filter housing cap. Use all-purpose cleaning spray.
Step 10

Unscrew the filter housing cap together with the old filter element. Use a drive socket #36. Use a ratchet wrench.
Step 11

Put the old oil filter in the container.

Replacement: engine oil and filter – VAUXHALL VECTRA (B) Hatchback. Tip from AUTODOC:
Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
Step 12

Detach the oil filter from the filter cover.
Step 13

Remove the oil filter cover O-ring. Use a flat screwdriver.
Step 14

Clean the oil filter housing cap. Use all-purpose cleaning spray.
Step 15

Remove the oil filter cover O-ring. Use a flat screwdriver.

Step 16

Install new O-rings and a new oil filter to their mounting seats on the filter cover.

Please note!
Make sure to install the filter correctly. Don't mix up the sides of the part.
Step 17

Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 18

Install a new oil filter housing cover and tighten it. Use a drive socket #36. Use a torque wrench. Tighten it to 25 Nm torque.

AUTODOC recommends:
Wait until the oil has completely drained from the drainage hole.
Step 19

Clean the area of the oil pan drainage hole.
Step 20

Screw in the new drainage plug and tighten it. Use Torx T45. Use a torque wrench. Tighten it to 20 Nm torque.
Step 21

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 22

Lower the car.

Step 23

Remove the oil filler cap.
Step 24

Insert the funnel.
Step 25

Pour new oil into the engine in the amount recommended by the car manufacturer.

Replacement: engine oil and filter – VAUXHALL VECTRA (B) Hatchback. AUTODOC recommends:
Use the oil recommended by the manufacturer.
Step 26

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 27

Install the oil filler cap.

Step 28

Tighten the oil filler cap.
Step 29

Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.

Step 30

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 31

Remove the fender protection cover.

Step 32

Close the hood.

Replacement: engine oil and filter – VAUXHALL VECTRA (B) Hatchback. Tip from AUTODOC experts:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VAUXHALL Vectra Mk1 (B) CC (J96) model.

VAUXHALL VECTRA (B) Hatchback tyre size

How to change fuel filter on VAUXHALL Vectra (B) CC (J96) – replacement guide

Free download PDF
778.24 KB
How to change serpentine belt on VAUXHALL Vectra (B) CC (J96) – replacement guide

Free download PDF
778.24 KB
How to change spark plugs on VAUXHALL Vectra (B) CC (J96) – replacement guide

Free download PDF
1.86 MB
How to change front lower arm on VAUXHALL Vectra (B) CC (J96) – replacement guide

Free download PDF
1.98 MB
How to change front suspension strut on VAUXHALL Vectra (B) CC (J96) – replacement guide

Free download PDF
2.49 MB
How to change engine thermostat on VAUXHALL Vectra (B) CC (J96) – replacement guide

Free download PDF
2.42 MB

How to change engine oil and filter on VAUXHALL Vectra Mk II (C) CC (Z02) – replacement guide

Free download PDF
1.61 MB
How to change engine oil and filter on VAUXHALL Vectra Mk II (C) Estate (Z02) – replacement guide

Free download PDF
1.59 MB
How to change engine oil and filter on VAUXHALL Vectra Mk II (C) Saloon (Z02) – replacement guide

Free download PDF
1.61 MB
How to change engine oil and filter on VAUXHALL Vectra (B) Saloon (J96) – replacement guide

Free download PDF
1.59 MB
How to change engine oil and filter on VAUXHALL Vectra (B) Estate (J96) – replacement guide

Free download PDF
1.59 MB
How to change engine oil and filter on a car – replacement tutorial

Universal

Free download PDF
2.82 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

The most common problems when buying a used car | AUTODOC

4K views

Published on: 10/11/2022
TOP 4 car cleaning products | AUTODOC tips

2K views

Published on: 26/08/2021
How to shine your tyres | AUTODOC tips

3K views

Published on: 07/04/2022
What to do if the ABS light comes on | AUTODOC tips

6K views

Published on: 11/03/2021