When to replace the Oil Filter on your SEAT TOLEDO
Recommended replacement interval for the part category Oil filter : 1 year / 15000 km
Important!
This replacement procedure can be used for:
SEAT Toledo II Saloon (1M2) 1.4 16V, SEAT Toledo II Saloon (1M2) 1.6 16V View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Oil Filter for Toledo II Saloon (1M2) and other SEAT models
Tools
Replacement: engine oil and filter – SEAT TOLEDO II (1M2). Tools you need:
Wire brush
All-purpose cleaning spray
Torque wrench
Drive socket # 19
Drive socket # 30
Ratchet wrench
Oil drain pan
Funnel
Fender cover
Replacement: engine oil and filter – SEAT TOLEDO II (1M2). AUTODOC recommends:
  • Replace the oil filter every time when changing motor oil.
  • Wear gloves to prevent contact with hot liquid.
  • All work should be done with the engine stopped.
Replacement: engine oil and filter – SEAT TOLEDO II (1M2). Take the following steps:
  1. Step 1
    Open the hood.
    Step 2
    Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.
    Step 3
    How to change Oil Filter on Seat Toledo 1m 1998 - free PDF and video manuals
    Unscrew the oil filler plug.
  2. Step 4
    Lift the car using a jack or place it over an inspection pit.
    AUTODOC recommends:
    The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
    Step 5
    How to replace SEAT Toledo II Saloon (1M2) 1.9 TDI 1999 Oil Filter - step-by-step manuals and video guides
    Put a waste oil container with at least 4 l capacity under the drainage hole.
  3. Step 6
    Seat Toledo 1m 1.6 16V 2000 Oil Filter replacement: free workshop manuals
    Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
  4. Step 7
    Changing Oil Filter on SEAT Toledo II Saloon (1M2) 1.8 20V 2001 by yourself
    Unscrew the drain plug. Use a drive socket #19. Use a ratchet wrench.
  5. Step 8
    How to remove SEAT TOLEDO 2.3 V5 2002 Oil Filter - online easy-to-follow instructions
    Drain the used oil.
    Replacement: engine oil and filter – SEAT TOLEDO II (1M2). Tip:
    Caution! The oil may be hot.
  6. Step 9
    How to replace Oil Filter on SEAT Toledo II Saloon (1M2) 2003: download PDF manuals and video instructions
    Clean the oil filter. Use all-purpose cleaning spray.
  7. Step 10
    Prepare a container for the old oil filter.
    Step 11
    How hard is it to do yourself: Oil Filter replacement on Seat Toledo 1m 1.8 20VT 2004 - download illustrated guide
    Unscrew the oil filter. Use a drive socket #30. Use a ratchet wrench.
  8. Step 12
    Need to know how to renew Oil Filter on SEAT TOLEDO 2005? This free workshop manual will help you to do it yourself
    Put the old oil filter in the container.
    Replacement: engine oil and filter – SEAT TOLEDO II (1M2). Tip from AUTODOC:
    Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
  9. Step 13
    Changing of Oil Filter on Seat Toledo 1m 2006 won't be an issue if you follow this illustrated step-by-step guide
    Clean the oil filter seat. Use all-purpose cleaning spray.
  10. Step 14
    SEAT TOLEDO 1.6 16V Oil Filter replacement: online guides and video tutorials
    Lubricate the rubber seal of the new filter with a little amount of fresh oil.
  11. Step 15
    Replacing Oil Filter on Seat Toledo 1m 1999 1.9 TDI by yourself
    Screw the new filter into its place. Use a drive socket #30. Use a torque wrench. Tighten it to 26 Nm torque.
    AUTODOC recommends:
    Wait until the oil has completely drained from the drainage hole.
  12. Step 16
    Toledo II Saloon (1M2) 2.3 V5 2000 Oil Filter DIY replacement workshop manual
    Clean the area of the oil pan drainage hole.
  13. Step 17
    How to change Oil Filter on SEAT Toledo II Saloon (1M2) 2001 - tips and tricks
    Screw in the new drainage plug and tighten it. Use a drive socket #19. Use a torque wrench. Tighten it to 27 Nm torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the SEAT Toledo II Saloon (1M2) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
SEAT Toledo II Saloon (1M2) Oil Filter replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY SEAT Toledo II Saloon (1M2) Oil Filter replacement - online guide
Tips & tricks for your SEAT Toledo II Saloon (1M2)
View more
  • How to change Oil filters on SEAT Toledo II Saloon (1M2) 1.6 - replacement tricks
    How to easily repair a punctured tyre | AUTODOC tips
  • Changing Engine oil filter Seat Toledo 1m 1.9 TDI - Replacement Tips
    How to prevent car windows from fogging up | AUTODOC tips
  • Maintenance Hacks - SEAT Toledo II Saloon (1M2) 1.6 16V Oil filters replacement guide
    How to Make a DIY Foam Sprayer | AUTODOC tips
  • Replace Engine oil filter on Seat Toledo 1m - free video tips
    TOP 5 mistakes during DIY oil change | AUTODOC tips