Recommended replacement interval for the part category Oil filter : 12 month / 15000 km

Important!

This replacement procedure can be used for:
BMW 6 Coupe (E63) 630i 3.0, BMW 6 Coupe (E63) 630i, BMW 6 Coupe (E63) 630i … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Oil filter

Replacement: engine oil and filter – BMW 6 (E63). Tools you might need:

                      All-purpose cleaning spray
                    
                      Drive socket # 17 
                    
                      Oil filter cup socket 86-16F
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Flat Screwdriver
                    
                      Funnel
                    
                      Oil drain pan
                    
                      Microfibre towel
                    
                      Fender cover

Buy tools

Replacement: engine oil and filter – BMW 6 (E63). AUTODOC recommends:

Replace the oil filter every time when changing motor oil.
Use only new O-rings during installation.
Wear gloves to prevent contact with hot liquid.
Please note: all work on the car – BMW 6 (E63) – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Unscrew the oil filler plug.
Step 4

Unscrew the filter housing cap together with the old filter element. Use the 86-16F socket. Use a ratchet wrench.
Step 5

Prepare a container for the old oil filter.
Step 6

Remove the oil filter.
Step 7

Put the old oil filter in the container.

Replacement: engine oil and filter – BMW 6 (E63). AUTODOC experts recommend:
Move up the container. The oil starts to drain out of the drainage hole immediately after you have removed the oil filter.
Step 8

Cover the oil filter housing with a microfibre towel to prevent dirt and foreign objects from getting into the system.
Step 9

Lift the car using a jack or place it over an inspection pit.

Replacement: engine oil and filter – BMW 6 (E63). Tip:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All work should be done with the engine stopped.
Step 10

Unscrew the fastener of the drain plug access panel. Use a flat screwdriver.

Step 11

Remove the drain plug access panel.
Step 12

Put a waste oil container with at least 7 l capacity under the drainage hole.
Step 13

Unscrew the drain plug. Use a drive socket #17. Use a ratchet wrench.
Step 14

Drain the used oil.

Replacement: engine oil and filter – BMW 6 (E63). AUTODOC experts recommend:
Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole.
Step 15

Clean the area of the oil pan drainage hole.
Step 16

Screw in the new drainage plug and tighten it. Use a drive socket #17. Use a torque wrench. Tighten it to 30 Nm torque.
Step 17

Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 18

Install the drain plug access panel.
Step 19

Screw in the fastener of the drain plug access panel. Use a flat screwdriver.
Step 20

Lower the car.

Step 21

Detach the oil filter from the filter cover.
Step 22

Remove old o-rings from the oil filter cover. Use a flat screwdriver.
Step 23

Clean the oil filter housing cap. Use all-purpose cleaning spray.
Step 24

Install new O-rings and a new oil filter to their mounting seats on the filter cover.

Please note!
Make sure to install the filter correctly. Don't mix up the sides of the part.
Step 25

Remove the microfibre towel from the oil filter housing.
Step 26

Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 27

Screw the new filter into its place.
Step 28

Install a new oil filter housing cover and tighten it. Use the 86-16F socket. Use a torque wrench. Tighten it to 25 Nm torque.
Step 29

Remove the oil filler cap. Insert the funnel.
Step 30

Pour new oil into the engine in the amount recommended by the car manufacturer.

Replacement: engine oil and filter – BMW 6 (E63). AUTODOC recommends:
Use the oil recommended by the manufacturer.
Step 31

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 32

Tighten the oil filler cap.
Step 33

Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.

Step 34

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 35

Remove the fender protection cover.

Step 36

Close the hood.

Replacement: engine oil and filter – BMW 6 (E63). Tip from AUTODOC experts:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the BMW 6 Coupe (E63) model

BMW E63 tyre size

How to change fuel filter on BMW 6 Coupe (E63) – replacement guide

Free download PDF
1.98 MB
How to change pollen filter on BMW 6 Coupe (E63) – replacement guide

Free download PDF
1.51 MB
How to change front wheel bearing on BMW 6 Coupe (E63) – replacement guide

Free download PDF
3.68 MB
How to change spark plugs on BMW 6 Coupe (E63) – replacement guide

Free download PDF
2.6 MB
How to change front windshield wipers on BMW 6 Coupe (E63) – replacement guide

Free download PDF
1.38 MB
How to change rear anti roll bar links on BMW 6 Coupe (E63) – replacement guide

Free download PDF
1.28 MB

How to change engine oil and filter on BMW 6 Coupe (F13) – replacement guide

Free download PDF
1.62 MB
How to change engine oil and filter on BMW 6 Gran Coupe (F06) – replacement guide

Free download PDF
1.62 MB
How to change engine oil and filter on BMW 6 Convertible (E64) – replacement guide

Free download PDF
1.62 MB
How to change engine oil and filter on BMW 6 Convertible (F12) – replacement guide

Free download PDF
1.62 MB
How to change engine oil and filter on a car – replacement tutorial

Universal

Free download PDF
2.82 MB
How to change engine oil and filter on BMW E90 diesel – replacement guide

Free download PDF
2.18 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Top 5 mistakes when replacing spark plugs | AUTODOC tips

37K views

Published on: 13/07/2023
Transform Your Old Engine Valve Cover: Quick Polishing Tips for a Shiny Finish | AUTODOC Tips

11K views

Published on: 30/11/2023
TOP 8 mistakes car owners make | AUTODOC tips

14K views

Published on: 09/12/2021
DIY rear axle restoration | Drivetrain restoration – Part 2

7K views

Published on: 07/11/2024