Recommended replacement interval for the part category Oil filter : 12 month / 15000 km

Important!

This replacement procedure can be used for:
ALPINA D3 (E90) 2.0 … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Oil Filter for D3 (E90) and other ALPINA models

Alternative products

Oil filter

Replacement: engine oil and filter – BMW E90. Tools you need:

                      Wire brush
                    
                      WD-40 spray
                    
                      All-purpose cleaning spray
                    
                      Drive socket # 8 
                    
                      Drive socket # 17 
                    
                      Drive socket # 36 
                    
                      Flat screwdriver
                    
                      Ratchet wrench
                    
                      Torque wrench
                    
                      Oil drain pan
                    
                      Funnel
                    
                      Microfibre towel
                    
                      Fender cover

Buy tools

Replacement: engine oil and filter – BMW E90. AUTODOC recommends:

Replace the oil filter every time when changing motor oil.
Wear gloves to prevent contact with hot liquid.
Use only new O-rings during installation.
Warning! Shut down the engine before starting any work – BMW E90

Carry out replacement in the following order:

Step 1

Open the hood.

Step 2

Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.

Step 3

Unscrew the oil filler plug.
Step 4

Unscrew the filter housing cap together with the old filter element. Use a drive socket #36. Use a ratchet wrench.
Step 5

Put the old filter cartridge in the container.
Step 6

Cover the oil filter housing with a microfibre towel to prevent dirt and foreign objects from getting into the system.
Step 7

Lift the car using a jack or place it over an inspection pit.

Replacement: engine oil and filter – BMW E90. AUTODOC recommends:
The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.
Step 8

Undo the fasteners of the oil pan lower cover.
Step 9

Remove the oil pan cover. Use a drive socket #8. Use a ratchet wrench.
Step 10

Put a waste oil container with at least 6 l capacity under the drainage hole.
Step 11

Clean the area of the oil pan drainage hole. Use a wire brush. Use WD-40 spray.
Step 12

Unscrew the drain plug. Use a drive socket #17. Use a ratchet wrench.
Step 13

Drain the used oil.

Replacement: engine oil and filter – BMW E90. Tip from AUTODOC:
Caution! The oil may be hot.
Step 14

Detach the oil filter from the filter cover.
Step 15

Remove the oil filter cover O-ring. Use a flat screwdriver.
Step 16

Clean the oil filter housing cap. Use all-purpose cleaning spray.
Step 17

Install a new O-ring to its mounting seat on the filter cover.
Step 18

Install the new oil filter to the mounting seat on the filter cover.

Please note!
Make sure to install the filter correctly. Don't mix up the sides of the part.
Step 19

Remove the O-ring from the plug.
Step 20

Clean the plug and put a new O-ring on it.

Replacement: engine oil and filter – BMW E90. Tip from AUTODOC experts:
Wait until the oil has completely drained from the drainage hole.
Step 21

Screw in the new drainage plug and tighten it. Use a drive socket #17. Use a torque wrench. Tighten it to 25 Nm torque.

Step 22

Clean the area of the oil pan drainage hole.
Step 23

Reinstall the oil pan lower cover.
Step 24

Tighten the fasteners of the oil pan lower cover. Use a drive socket #8. Use a ratchet wrench.
Step 25

Lower the car.

Step 26

Remove the microfibre towel from the oil filter housing.
Step 27

Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 28

Screw the new filter into its place.
Step 29

Screw the cap. Use a drive socket #36. Use a torque wrench. Tighten it to 25 Nm torque.
Step 30

Remove the oil filler cap. Insert the funnel.
Step 31

Pour new oil into the engine in the amount recommended by the car manufacturer.

Replacement: engine oil and filter – BMW E90. AUTODOC experts recommend:
Use the oil recommended by the manufacturer.
Step 32

Check the oil level using the dipstick. Top up oil if necessary.

Please note!
The oil level should be between the Min and Max marks.
Step 33

Tighten the oil filler cap.

Step 34

Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.

Step 35

Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.

Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 36

Remove the fender protection cover.

Step 37

Close the hood.

Replacement: engine oil and filter – BMW E90. Tip:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the ALPINA D3 Saloon (E90) model

Alpina D3 E90 tyre size

How to change fuel filter on ALPINA D3 (E90) – replacement guide

Free download PDF
1.46 MB
How to change pollen filter on ALPINA D3 (E90) – replacement guide

Free download PDF
962.56 KB
How to change rear brake pads on ALPINA Roadster V8 (E52) – replacement guide

Free download PDF
1.78 MB
How to change front brake pads on ALPINA B10 Estate (E39) – replacement guide

Free download PDF
1.98 MB
How to change front brake pads on ALPINA Roadster V8 (E52) – replacement guide

Free download PDF
1.98 MB
How to change front brake pads on ALPINA B10 (E39) – replacement guide

Free download PDF
1.98 MB

How to change engine oil and filter on ALPINA D3 Estate (E91) – replacement guide

Free download PDF
1.73 MB
How to change engine oil and filter on a car – replacement tutorial

Universal

Free download PDF
2.82 MB
How to change engine oil and filter on ALPINA Roadster V8 (E52) – replacement guide

Free download PDF
1.79 MB
How to change engine oil and filter on ALPINA B12 (E32) – replacement guide

Free download PDF
1.79 MB
How to change engine oil and filter on ALPINA B8 Touring (E36) – replacement guide

Free download PDF
1.79 MB
How to change engine oil and filter on ALPINA B8 Convertible (E36) – replacement guide

Free download PDF
1.79 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Which Coolant is Best? Comparison Test | AUTODOC

7K views

Published on: 13/10/2022
TOP 5 mistakes when replacing shock absorbers | AUTODOC tips

14K views

Published on: 15/06/2023
What to do if your check engine light is on | AUTODOC tips

19K views

Published on: 19/08/2020
The most common problems when buying a used car | AUTODOC

4K views

Published on: 10/11/2022