Important!

This replacement procedure can be used for:
VOLVO XC70 Cross Country (295) 2.4 T XC AWD, VOLVO XC70 Cross Country (295) D5 XC AWD, VOLVO XC70 Cross Country (295) 2.5 T XC AWD, VOLVO XC70 Cross Country (295) D5 AWD … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Track Rod End for XC70 Cross Country (295) and other VOLVO models

Track rod end

Rod Assembly

Repair Kit, tie rod

Mounting Kit, tie rod end

        Track rod end for VOLVO XC70 Cross Country (295) 2.4 T XC AWD Petrol (200 hp)
      
        Track rod end for VOLVO XC70 Cross Country (295) D5 XC AWD Diesel (163 hp)
      
        Track rod end for VOLVO XC70 Cross Country (295) 2.5 T XC AWD Petrol (209 hp)
      
        Track rod end for VOLVO XC70 Cross Country (295) D5 AWD Diesel (185 hp)

Replacement: track rod end – VOLVO XC70 CROSS COUNTRY. List of the tools you'll need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner 
                      
                        Copper grease 
                      
                        Combination spanner #13
                      
                        Combination spanner #19
                      
                        Combination spanner #21
                      
                        Wheel impact socket #19
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Adjustable wrench
                      
                        Vernier caliper
                      
                        Wheel chock

Buy tools

Replacement: track rod end – VOLVO XC70 CROSS COUNTRY. AUTODOC experts recommend:

Replace tie rod ends in pairs.
The replacement procedure is identical for the right and left tie rod ends.
Please note: all work on the car – VOLVO XC70 CROSS COUNTRY – should be done with the engine switched off.

Carry out replacement in the following order:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #19.
Step 3

Raise the front of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. VOLVO XC70 CROSS COUNTRY
Step 5

Remove the wheel.
Step 6

When deinstalling, mark or measure the precise position of the ball joint on the track rod, or count the number of turns in order to prevent misalignment afterward. Use a vernier caliper.
Step 7

Clean the fastener connecting the tie rod end to the steering knuckle. Use a wire brush. Use WD-40 spray.
Step 8

Unscrew the end fastening nut to the steering knuckle. Use a combination spanner #19. Use an adjustable wrench.
Step 9

Clean the lock nut that connects the tie rod to the tie rod end. Use a wire brush. Use WD-40 spray.

Step 10

Loosen the lock nut securing the tie rod end to the tie rod. Use a combination spanner #21.
Step 11

Disconnect the tie rod end from the steering knuckle.
Step 12

Screw the end out of the tie rod. Use a combination spanner #13.
Step 13

Clean the mounting seats of the tie rod end. Use a wire brush. Use WD-40 spray.
Step 14

Screw on a new tie rod end.

Replacement: track rod end – VOLVO XC70 CROSS COUNTRY. Professionals recommend:
While installing the steering rod end remember to make the same number of turns or to leave the same length of thread showing as per your measurements.
Step 15

Connect the tie rod end to the steering knuckle.

Step 16

Tighten the fastening nut connecting the tie rod end to the steering knuckle. Use an adjustable wrench. Use a combination spanner #19. Use a torque wrench. Tighten it to 50 Nm torque.+35°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 17

Tighten the tie rod end locknut. Use a combination spanner #21. Use a torque wrench. Tighten it to 70 nm torque.
Step 18

Treat all tie rod end connections. Use copper grease.
Step 19

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 20

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: track rod end – VOLVO XC70 CROSS COUNTRY. After applying the spray, wait a few minutes.
Step 21

Install the wheel.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while screwing in the fastening bolts on the car. VOLVO XC70 CROSS COUNTRY
Step 22

Screw in the wheel bolts. Use wheel impact socket #19.
Step 23

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #19. Use a torque wrench. Tighten it to 140 nm torque.

Replacement: track rod end – VOLVO XC70 CROSS COUNTRY. Professionals recommend:
Check and adjust wheel alignment if necessary.
Step 24

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change front ball joint on VOLVO XC70 Cross Country (295) – replacement guide

Free download PDF
1.53 MB
How to change front strut mount on VOLVO XC70 Cross Country (295) – replacement guide

Free download PDF
2.4 MB
How to change rear anti roll bar links on VOLVO XC70 Cross Country (295) – replacement guide

Free download PDF
778.24 KB
How to change front anti roll bar links on VOLVO XC70 Cross Country (295) – replacement guide

Free download PDF
1.2 MB
How to change front brake pads on VOLVO XC70 Cross Country (295) – replacement guide

Free download PDF
1.58 MB
How to change rear brake pads on VOLVO XC70 Cross Country (295) – replacement guide

Free download PDF
1.54 MB

How to change track rod end on a car – replacement tutorial

Universal

Free download PDF
1.31 MB
How to change track rod end on Volvo V70 SW – replacement guide

Free download PDF
1.53 MB
How to change track rod end on Volvo XC90 1 – replacement guide

Free download PDF
1.51 MB
How to change track rod end on VOLVO S60 I (384) – replacement guide

Free download PDF
1.47 MB
How to change track rod end on VOLVO S80 I (184) – replacement guide

Free download PDF
1.47 MB
How to change track rod end on VW Polo 9N – replacement guide

Free download PDF
2.23 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

5 car interior cleaning mistakes | AUTODOC tips

6K views

Published on: 26/05/2022
Important differences between car tools | AUTODOC tips

7K views

Published on: 16/12/2021
Coolant comparison test | AUTODOC

4K views

Published on: 13/10/2022
How to unlock your car without a key | AUTODOC tips

834K views

Published on: 15/09/2022