Disclaimer
How to change spark plugs on SKODA Rapid Hatchback (NH3) – replacement guide
downloads:
2
Views:
28
Recommended replacement interval for the part category Spark plug : 4 year / 60000 km
Important!
This replacement procedure can be used for:
SKODA Rapid Hatchback (NH3) 1.2 … View more
The steps may slightly vary depending on the car design.
SKODA Rapid Hatchback (NH3) 1.2 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Spark Plug for Rapid Hatchback (NH3) and other SKODA models
Alternative products

Electronic spray
High-temperature anti-seize lubricant
Spark plug socket # 16
Ratchet wrench
Torque wrench
Flat Screwdriver
Crow bar
Microfibre towel
Fender cover
Replacement: spark plugs – SKODA RAPID (NH3). AUTODOC experts recommend:
- The replacement procedure is the same for all spark plugs.
- All work should be done with the engine stopped.
Replacement: spark plugs – SKODA RAPID (NH3). Take the following steps:
- Step 1Open the hood.Step 2Use a fender protection cover to prevent damaging paintwork and plastic parts of the car.Step 3
Remove the engine cover. - Step 4
Cover the throttle body with a microfibre towel to prevent dust and dirt from getting into the system. - Step 5
Undo the plastic locking tabs of the ignition coil connector. Use a flat screwdriver. - Step 6
Pry up the ignition coil. Use a crowbar (2 pieces). - Step 7
Take out the ignition coil from the spark plug well.Replacement: spark plugs – SKODA RAPID (NH3). AUTODOC recommends:Remember the sequence of steps for ignition coil demounting. - Step 8
Unplug the connectors from the ignition coils. - Step 9
Clean dirt, dust and debris from inside the spark plug wells. - Step 10
Unscrew the spark plugs. Use the spark plug socket #16. Use a ratchet wrench. - Step 11
Take out the spark plugs. - Step 12
Apply a thin layer of a special high temperature anti-seize lubricant to the threads of the new spark plugs. Treat the surface of the terminals of the new spark plugs. Use high-temperature grease. - Step 13
Install the new spark plugs into their mounting seats. - Step 14
Screw new spark plugs and tighten them. Use the spark plug socket #16. Use a torque wrench. Tighten it to 25 nm torque.Replacement: spark plugs – SKODA RAPID (NH3). Professionals recommend:Don't tighten the plugs with excessive force. Exceeding tightening torque can damage the thread connection. Be careful when working with a spark plug wrench. Its skewing can cause damage to the threaded connection.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the SKODA Rapid Hatchback (NH3) model
Popular maintenance tutorials for Skoda Rapid NH3
Complete guides for changing the Engine spark plug on different SKODA RAPID models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your SKODA Rapid Hatchback (NH3)
View more
Checking the starter without removing it | AUTODOC tips
Top 5 mistakes when replacing spark plugs | AUTODOC tips
DIY rear axle restoration | Drivetrain restoration – Part 2
Top 5 car noises you shouldn't ignore
Most commonly replaced car parts on SKODA RAPID
Time to replace parts? Get even better deals in our Shop app.

SCAN ME























