Important!
This replacement procedure can be used for:
AUDI TT Roadster (8N9) 1.8 T, AUDI TT Roadster (8N9) 1.8 T, AUDI TT Roadster (8N9) 1.8 T, AUDI TT Roadster (8N9) 1.8 T View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Tools
Replacement: wheel bearing – AUDI TT Roadster (8N9). Tools you might need:
Wire brush
WD-40 spray
Brake cleaner
Torx bit T30
Combination spanner #13
Combination spanner #15
Drive socket # 13
Torque wrench
Copper grease
Wheel impact socket #17
Flat chisel
Hammer
3-Arm Gear Puller
12-point socket # 32
Rubber mallet
Crow bar
Wheel chock
Replacement: wheel bearing – AUDI TT Roadster (8N9). AUTODOC experts recommend:
  • The replacement procedure is identical for the left and right wheel hubs on the same axle.
  • All work should be done with the engine stopped.
Replacement: wheel bearing – AUDI TT Roadster (8N9). Use the following procedure:
  1. Step 1
    How to change Wheel Bearing on Audi TT 8N Roadster 1999 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 2
    How to replace AUDI TT Roadster (8N9) 1.8 T 2000 Wheel Bearing - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  3. Step 3
    Raise the rear of the car and secure on supports.
    Step 4
    Audi TT 8N Roadster 1.8 T quattro 2001 Wheel Bearing replacement: free workshop manuals
    Unscrew the wheel bolts.
    AUTODOC recommends:
    Important! Hold the wheel while unscrewing the fastening bolts. AUDI TT Roadster (8N9)
  4. Step 5
    Changing Wheel Bearing on AUDI TT Roadster (8N9) 1.8 T 2002 by yourself
    Remove the wheel.
  5. Step 6
    How to remove AUDI TT 1.8 T quattro 2003 Wheel Bearing - online easy-to-follow instructions
    Spread the brake pads. Use a crowbar.
  6. Step 7
    How to replace Wheel Bearing on AUDI TT Roadster (8N9) 2004: download PDF manuals and video instructions
    Unscrew the brake caliper fastening. Use a combination spanner #13. Use a combination spanner #15.
  7. Step 8
    How hard is it to do yourself: Wheel Bearing replacement on Audi TT 8N Roadster 1.8 T 2005 - download illustrated guide
    Remove the brake caliper.
    Replacement: wheel bearing – AUDI TT Roadster (8N9). Tip:
    Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
  8. Step 9
    Need to know how to renew Wheel Bearing on AUDI TT 2006? This free workshop manual will help you to do it yourself
    Remove the brake pads.
  9. Step 10
    Changing of Wheel Bearing on Audi TT 8N Roadster 1999 won't be an issue if you follow this illustrated step-by-step guide
    Unscrew the brake disc mounting bolts and remove it. Use Torx T30.
    Replacement: wheel bearing – AUDI TT Roadster (8N9). AUTODOC recommends:
    If necessary, use a rubber mallet.
  10. Step 11
    AUDI TT 3.2 VR6 quattro Wheel Bearing replacement: online guides and video tutorials
    Pry up and remove the wheel hub cap. Use a crowbar.
    Replacement: wheel bearing – AUDI TT Roadster (8N9). Tip from AUTODOC experts:
    If necessary, use a flat chisel and a hammer.
  11. Step 12
    Replacing Wheel Bearing on Audi TT 8N Roadster 2001 1.8 T by yourself
    Unscrew the wheel hub fastening nut. Use drive 12-point socket #32.
  12. Step 13
    TT Roadster (8N9) 1.8 T quattro 2002 Wheel Bearing DIY replacement workshop manual
    Clean the hub. Use WD-40 spray.
  13. Step 14
    How to change Wheel Bearing on AUDI TT Roadster (8N9) 2003 - tips and tricks
    Remove the hub and the bearing together, since they are a sealed unit. Use 3-Arm Gear Puller.
  14. Step 15
    Step-by-step recommendations for DIY replacement Audi TT 8N Roadster 2004 1.8 T quattro Wheel Bearing
    Clean the guiding part of the stub axle. Use a wire brush.
    Replacement: wheel bearing – AUDI TT Roadster (8N9). Tip from AUTODOC:
    Be careful to avoid damaging the guiding part of the stub axle.
  15. Step 16
    DIY replacement of Wheel Bearing on AUDI TT Roadster (8N9) 3.2 VR6 quattro 2005 is not an issue anymore with our step-by-step tutorial
    Clean the hub bearing mounting seat. Use a wire brush. Use WD-40 spray.
  16. Step 17
    How to change Wheel Bearing on Audi TT 8N Roadster 1999 - free PDF and video manuals
    Apply special grease to the bearing assembly mounting seat.
  17. Step 18
    How to replace AUDI TT Roadster (8N9) 1.8 T 2000 Wheel Bearing - step-by-step manuals and video guides
    Install the new wheel hub with a bearing.
  18. Step 19
    Audi TT 8N Roadster 1.8 T quattro 2001 Wheel Bearing replacement: free workshop manuals
    Move the hub as far as it can go.
  19. Step 20
    Changing Wheel Bearing on AUDI TT Roadster (8N9) 1.8 T 2002 by yourself
    Screw the wheel hub lock nut.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the AUDI TT Roadster (8N9) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
AUDI TT Roadster (8N9) Wheel Bearing replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY AUDI TT Roadster (8N9) Wheel Bearing replacement - online guide
Tips & tricks for your AUDI TT Roadster (8N9)
View more
  • How to change Wheel bearings on AUDI TT Roadster (8N9) 3.2 VR6 quattro - replacement tricks
    How to restore wheel rims | AUTODOC tips
  • Changing Hub bearing Audi TT 8N Roadster 1.8 T - Replacement Tips
    How do EGR valves work? | AUTODOC
  • Maintenance Hacks - AUDI TT Roadster (8N9) 1.8 T quattro Wheel bearing kit replacement guide
    How to unlock your car without a key | AUTODOC tips
  • Replace Wheel hub bearing on Audi TT 8N Roadster - free video tips
    What to do if your car heater isn't working | AUTODOC tips

Professional manuals for the most common AUDI models