Important!
This replacement procedure can be used for:
VW Polo Classic (6V2) 1.6 View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Shock Absorber for Polo Classic (6V2) and other VW models
Tools
Replacement: shock absorbers – VW POLO CLASSIC (6KV2). Tools you need:
Wire brush
WD-40 spray
Copper grease
Combination spanner #16
Drive socket # 16
Torx bit T27
Wheel impact socket #17
Ratchet wrench
Torque wrench
Shock absorber socket #DD6
Vice
Crow bar
Hydraulic transmission jack
Wheel chock
Replacement: shock absorbers – VW POLO CLASSIC (6KV2). AUTODOC experts recommend:
  • Both shock absorbers of the rear suspension should be replaced simultaneously.
  • The replacement procedure is identical for the left and right shock absorbers of the rear suspension.
  • Warning! Shut down the engine before starting any work – VW POLO CLASSIC (6KV2).
Carry out replacement in the following order:
  1. Step 1
    How to change Shock Absorber on VW Polo Classic 6kv 1995 - free PDF and video manuals
    Secure the wheels with chocks.
  2. Step 2
    How to replace VW Polo Classic (6V2) 1.4 1996 Shock Absorber - step-by-step manuals and video guides
    Loosen the wheel mounting bolts. Use wheel impact socket #17.
  3. Step 3
    Raise the rear of the car and secure on supports.
    Step 4
    VW Polo Classic 6kv 1.6 1997 Shock Absorber replacement: free workshop manuals
    Unscrew the wheel bolts.
    Replacement: shock absorbers – VW POLO CLASSIC (6KV2). AUTODOC recommends:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  4. Step 5
    Changing Shock Absorber on VW Polo Classic (6V2) 1.9 SDI 1998 by yourself
    Remove the wheel.
  5. Step 6
    How to remove VW POLO 1.9 TDI 1999 Shock Absorber - online easy-to-follow instructions
    Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.
  6. Step 7
    How to replace Shock Absorber on VW Polo Classic (6V2) 2000: download PDF manuals and video instructions
    Unscrew the lower fastener of the shock absorber. Use a combination spanner #16. Use a drive socket #16. Use a ratchet wrench.
  7. Step 8
    How hard is it to do yourself: Shock Absorber replacement on VW Polo Classic 6kv 1.6 2001 - download illustrated guide
    Unscrew the wheel arch cover fasteners. Use Torx T27.
  8. Step 9
    Need to know how to renew Shock Absorber on VW POLO 2002? This free workshop manual will help you to do it yourself
    Support the rear suspension beam. Use a hydraulic transmission jack.
  9. Step 10
    Changing of Shock Absorber on VW Polo Classic 6kv 2003 won't be an issue if you follow this illustrated step-by-step guide
    Clean the shock absorber fasteners. Use a wire brush. Use WD-40 spray.
  10. Step 11
    VW POLO 1.9 SDI Shock Absorber replacement: online guides and video tutorials
    Unscrew the upper fastener of the shock absorber. Use a drive socket #16. Use a ratchet wrench.
  11. Step 12
    Replacing Shock Absorber on VW Polo Classic 6kv 2005 1.4 by yourself
    Remove the fastening bolt. Use a drive socket #16. Use a ratchet wrench.
    AUTODOC recommends:
    Important! Hold the shock absorber while unscrewing the fastening bolts. VW POLO CLASSIC (6KV2)
  12. Step 13
    Polo Classic (6V2) 1.9 TDI 2006 Shock Absorber DIY replacement workshop manual
    Lower the hydraulic transmission jack by 10-15 cm.
    Replacement: shock absorbers – VW POLO CLASSIC (6KV2). Tip:
    Lower the hydraulic transmission jack smoothly, without jerks, to avoid damaging assemblies and mechanisms.
  13. Step 14
    How to change Shock Absorber on VW Polo Classic (6V2) 1995 - tips and tricks
    Remove the shock absorber.
  14. Step 15
    Step-by-step recommendations for DIY replacement VW Polo Classic 6kv 1996 1.9 TDI Shock Absorber
    Grip the shock absorber in a vice.
  15. Step 16
    DIY replacement of Shock Absorber on VW Polo Classic (6V2) 1.4 16V 1997 is not an issue anymore with our step-by-step tutorial
    Remove the protective cap of the shock absorber mount. Use a crowbar.
  16. Step 17
    How to change Shock Absorber on VW Polo Classic 6kv 1995 - free PDF and video manuals
    Clean the shock absorber rod fastener. Use a wire brush. Use WD-40 spray.
  17. Step 18
    How to replace VW Polo Classic (6V2) 1.4 1996 Shock Absorber - step-by-step manuals and video guides
    Remove the shock absorber piston rod fastening. Use a shock absorber socket DD№6. Use a drive socket #16. Use a ratchet wrench.
  18. Step 19
    VW Polo Classic 6kv 1.6 1997 Shock Absorber replacement: free workshop manuals
    Remove the shock absorber mount, boot and bump stop.
    AUTODOC recommends:
    Replacement: shock absorbers – VW POLO CLASSIC (6KV2). Carefully inspect the mount, the boot, and the bump stop of the shock absorber. Replace if necessary.Before installing a new shock absorber you should pump it manually 3-5 times.
  19. Step 20
    Changing Shock Absorber on VW Polo Classic (6V2) 1.9 SDI 1998 by yourself
    Install the mount, boot and bump stop onto a new shock absorber.
  20. Step 21
    How to remove VW POLO 1.9 TDI 1999 Shock Absorber - online easy-to-follow instructions
    Screw the shock strut piston rod upper fastening. Use a shock absorber socket DD№6. Use a drive socket #16. Use a torque wrench. Tighten it to 25 nm torque.
  21. Step 22
    How to replace Shock Absorber on VW Polo Classic (6V2) 2000: download PDF manuals and video instructions
    Treat the shock absorber rod fastener. Use copper grease.
  22. Step 23
    How hard is it to do yourself: Shock Absorber replacement on VW Polo Classic 6kv 1.6 2001 - download illustrated guide
    Install the protective cap of the shock absorber mount.
  23. Step 24
    Need to know how to renew Shock Absorber on VW POLO 2002? This free workshop manual will help you to do it yourself
    Release the vice and take out the shock absorber.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Searching for the right tyres?

Find out which tyre and wheel sizes are compatible with the VW Polo III Classic (6V2) model.

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
VW Polo Classic (6V2) Shock Absorber replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY VW Polo Classic (6V2) Shock Absorber replacement - online guide
Tips & tricks for your VW Polo Classic (6V2)
View more
  • How to change Shocks on VW Polo Classic (6V2) 1.4 16V - replacement tricks
    How to remove rust | AUTODOC tips
  • Changing Shock absorbers VW Polo Classic 6kv 1.4 - Replacement Tips
    How to shine your tyres | AUTODOC tips
  • Maintenance Hacks - VW Polo Classic (6V2) 1.6 Struts replacement guide
    What to do if your car heater isn't working | AUTODOC tips
  • Replace Struts and shocks on VW Polo Classic 6kv - free video tips
    Top 5 reasons why your car squeals | AUTODOC Tips