Disclaimer
How to change rear brake pads on VW New Beetle Hatchback (9C1, 1C1) – replacement guide
downloads:
17
Views:
352
Recommended replacement interval for the part category Brake pad set : 30000 km
Important!
This replacement procedure can be used for:
VW New Beetle Hatchback (9C1, 1C1) 2.0, VW New Beetle Hatchback (9C1, 1C1) 1.9 TDI, VW New Beetle Hatchback (9C1, 1C1) 1.6, VW New Beetle Hatchback (9C1, 1C1) 1.8 T, VW New Beetle Hatchback (9C1, 1C1) 3.2 RSI 4motion (1C9), VW New Beetle Hatchback (9C1, 1C1) 1.6, VW New Beetle Hatchback (9C1, 1C1) 2.3 V5, VW New Beetle Hatchback (9C1, 1C1) 1.9 TDI, VW New Beetle Hatchback (9C1, 1C1) 1.4, VW New Beetle Hatchback (9C1, 1C1) 1.9 TDI, VW New Beetle Hatchback (9C1, 1C1) 1.8 T, VW New Beetle Hatchback (9C1, 1C1) 2.5 … View more
The steps may slightly vary depending on the car design.
VW New Beetle Hatchback (9C1, 1C1) 2.0, VW New Beetle Hatchback (9C1, 1C1) 1.9 TDI, VW New Beetle Hatchback (9C1, 1C1) 1.6, VW New Beetle Hatchback (9C1, 1C1) 1.8 T, VW New Beetle Hatchback (9C1, 1C1) 3.2 RSI 4motion (1C9), VW New Beetle Hatchback (9C1, 1C1) 1.6, VW New Beetle Hatchback (9C1, 1C1) 2.3 V5, VW New Beetle Hatchback (9C1, 1C1) 1.9 TDI, VW New Beetle Hatchback (9C1, 1C1) 1.4, VW New Beetle Hatchback (9C1, 1C1) 1.9 TDI, VW New Beetle Hatchback (9C1, 1C1) 1.8 T, VW New Beetle Hatchback (9C1, 1C1) 2.5 … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Brake Pads for New Beetle Hatchback (9C1, 1C1) and other VW models
Alternative products

Wire brush
WD-40 spray
Brake cleaner
Anti-squeal paste
Copper grease
Combination spanner #13
Drive socket # 13
Wheel impact socket #17
Brake caliper wind back tool
Torque wrench
Crow bar
Wheel chock
Replacement: brake pads – VW NEW BEETLE (9C1, 1C1). AUTODOC experts recommend:
- Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
- The replacement procedure is identical for all brake pads on the same axle.
- Please note: all work on the car – VW NEW BEETLE (9C1, 1C1) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Open the bonnet. Unscrew the brake fluid reservoir cap.Step 2
Secure the wheels with chocks. - Step 3
Loosen the wheel mounting bolts. Use wheel impact socket #17. - Step 4Raise the rear of the car and secure on supports.Step 5
Unscrew the wheel bolts.AUTODOC recommends:Important! Hold the wheel while unscrewing the fastening bolts. VW NEW BEETLE (9C1, 1C1) - Step 6
Remove the wheel. - Step 7
Clean the brake caliper fasteners. Use a wire brush. Use WD-40 spray. - Step 8
Unscrew the brake caliper fastening. Use a combination spanner #13. - Step 9
Remove the brake caliper. Use a crowbar.Replacement: brake pads – VW NEW BEETLE (9C1, 1C1). Tip:Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary. - Step 10
Remove the brake pads.Replacement: brake pads – VW NEW BEETLE (9C1, 1C1). AUTODOC recommends:Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced. - Step 11
Treat the brake caliper piston. Use a brake cleaner.AUTODOC recommends:Replacement: brake pads – VW NEW BEETLE (9C1, 1C1). After applying the spray, wait a few minutes. - Step 12
Press in the brake caliper piston. Use brake caliper wind back tool. - Step 13
Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.Replacement: brake pads – VW NEW BEETLE (9C1, 1C1). Tip from AUTODOC:After applying the spray, wait a few minutes. - Step 14
Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.AUTODOC recommends:Make sure the disc surface is clean before installing the pads.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the VW New Beetle Hatchback (9C1, 1C1) model
Popular maintenance tutorials for VW Beetle 9c
Complete guides for changing the Brake pad set on different VW NEW BEETLE models
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your VW New Beetle Hatchback (9C1, 1C1)
View more
DIY vehicle AC compressor restoration
Top 5 brake repair mistakes | AUTODOC tips
#DIY Guide: How to Fix a Cracked Windscreen Without a Garage Visit
How to unlock your car without a key | AUTODOC tips
Most commonly replaced car parts on VW NEW BEETLE
Time to replace parts? Get even better deals in our Shop app.

SCAN ME






























