Important!
This replacement procedure can be used for:
NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0, NISSAN X-TRAIL (T31) 2.0

The steps may slightly vary depending on the car design.

How to change rear brake pads on NISSAN QASHQAI (J10, NJ10) [TUTORIAL AUTODOC]

Replacement: brake pads – Nissan Qashqai J10. Tools you might need:
Replacement: brake pads – Nissan Qashqai J10. Tools you might need:
Wire brush
Nylon cleaning brush
WD-40 spray
All-purpose cleaning spray
Brake cleaner
Anti-squeal paste
Brake caliper guide pins grease
Copper grease
Torque wrench
Drive socket # 14
Wheel impact socket #21
Brake caliper wind back tool
Tap wrench
Crow bar
Wheel chock
All the parts you need to replace – Brake Pads for Qashqai / Qashqai +2 I (J10, NJ10) and other NISSAN models
How to change Brake Pad Set, disc brake on Nissan Qashqai j10 1.5 dCi – step-by-step instructions for straightforward car repair
Brake Pad Set, disc brake
How to change Brake Pad Set, disc brake on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0 – tips for proper car maintenance
NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0
Simple DIY car repair steps – Replacing Brake Pad Set, disc brake on NISSAN X-TRAIL (T31) 2.0
NISSAN X-TRAIL (T31) 2.0
Replacement: brake pads – Nissan Qashqai J10. AUTODOC recommends:
  • Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
  • The replacement procedure is identical for all brake pads on the same axle.
  • All work should be done with the engine stopped.
Replacement: brake pads – Nissan Qashqai J10. Take the following steps:
  1. How to change Brake Pads on Nissan Qashqai j10 2006 - free PDF and video manuals
    Step 1
    Open the bonnet.Unscrew the brake fluid reservoir cap.
  2. How to replace NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.5 dCi 2007 Brake Pads - step-by-step manuals and video guides
    Step 2
    Secure the wheels with chocks.
  3. Nissan Qashqai j10 2.0 dCi Allrad 2008 Brake Pads replacement: free workshop manuals
    Step 3
    Loosen the wheel mounting bolts.Use wheel impact socket #21.
  4. Changing Brake Pads on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0 dCi 2009 by yourself
    Step 4
    Raise the rear of the car and secure on supports.
  5. How to remove NISSAN QASHQAI 1.6 dCi 2010 Brake Pads - online easy-to-follow instructions
    Step 5
    Unscrew the wheel bolts.
    Replacement: brake pads – Nissan Qashqai J10. Tip from AUTODOC experts:
    To avoid injury, hold up the wheel when unscrewing the bolts.
  6. How to replace Brake Pads on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2011: download PDF manuals and video instructions
    Step 6
    Remove the wheel.
  7. How hard is it to do yourself: Brake Pads replacement on Nissan Qashqai j10 2.0 Allrad 2012 - download illustrated guide
    Step 7
    Clean the brake caliper fasteners. Use a wire brush.Use WD-40 spray.Use all-purpose cleaning spray.
  8. Need to know how to renew Brake Pads on NISSAN QASHQAI ? This free workshop manual will help you to do it yourself
    Step 8
    Unscrew the brake caliper fastening.Use a drive socket #14.Use a tap wrench.
  9. Changing of Brake Pads on Nissan Qashqai j10 2006 won't be an issue if you follow this illustrated step-by-step guide
    Step 9
    Spread the brake pads.Use a crowbar.
  10. NISSAN QASHQAI 2.0 dCi Allrad Brake Pads replacement: online guides and video tutorials
    Step 10
    Remove the brake caliper.
    Replacement: brake pads – Nissan Qashqai J10. AUTODOC recommends:
    Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
  11. Replacing Brake Pads on Nissan Qashqai j10 2008 1.5 dCi by yourself
    Step 11
    Remove the brake pads.
    Replacement: brake pads – Nissan Qashqai J10. Tip:
    Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
  12. Qashqai / Qashqai +2 I (J10, NJ10) 1.6 dCi 2009 Brake Pads DIY replacement workshop manual
    Step 12
    Clean the brake caliper bracket from dirt and dust.Use a wire brush.Use all-purpose cleaning spray.
  13. How to change Brake Pads on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2010 - tips and tricks
    Step 13
    Treat the brake caliper piston.Use a nylon cleaning brush. Use a brake cleaner.
    Replacement: brake pads – Nissan Qashqai J10. AUTODOC experts recommend:
    After applying the spray, wait a few minutes.
  14. Step-by-step recommendations for DIY replacement Nissan Qashqai j10 2011 1.6 dCi Brake Pads
    Step 14
    Press in the brake caliper piston.Use brake caliper wind back tool.
  15. DIY replacement of Brake Pads on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.6 2012 is not an issue anymore with our step-by-step tutorial
    Step 15
    Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.
    Replacement: brake pads – Nissan Qashqai J10. Tip from AUTODOC:
    Make sure the disc surface is clean before installing the pads.
  16. How to change Brake Pads on Nissan Qashqai j10 2006 - free PDF and video manuals
    Step 16
    Install new brake pads.
    Replacement: brake pads – Nissan Qashqai J10. Professionals recommend:
    Make sure the pads are installed with linings facing the disc.
  17. How to replace NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.5 dCi 2007 Brake Pads - step-by-step manuals and video guides
    Step 17
    Clean the brake caliper guide pins.Use all-purpose cleaning spray.
  18. Nissan Qashqai j10 2.0 dCi Allrad 2008 Brake Pads replacement: free workshop manuals
    Step 18
    Treat the brake caliper guide pins.Use the brake caliper guide pin grease.
  19. Changing Brake Pads on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0 dCi 2009 by yourself
    Step 19
    Install the brake caliper and fix it.Use a drive socket #14.Use a torque wrench.Tighten it to 40 Nm torque.
  20. How to remove NISSAN QASHQAI 1.6 dCi 2010 Brake Pads - online easy-to-follow instructions
    Step 20
    Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
  21. How to replace Brake Pads on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2011: download PDF manuals and video instructions
    Step 21
    Clean the brake disk surface.Use a brake cleaner.
    AUTODOC recommends:
    Replacement: brake pads – Nissan Qashqai J10. After applying the spray, wait a few minutes.
  22. How hard is it to do yourself: Brake Pads replacement on Nissan Qashqai j10 2.0 Allrad 2012 - download illustrated guide
    Step 22
    Install the wheel.
    AUTODOC recommends:
    Important! Hold the wheel while screwing in the fastening bolts. Nissan Qashqai J10
  23. Need to know how to renew Brake Pads on NISSAN QASHQAI ? This free workshop manual will help you to do it yourself
    Step 23
    Screw in the wheel bolts.Use wheel impact socket #21.
  24. Changing of Brake Pads on Nissan Qashqai j10 2006 won't be an issue if you follow this illustrated step-by-step guide
    Step 24
    Lower the car and working in a cross order, tighten the wheel bolts.Use wheel impact socket #21.Use a torque wrench.Tighten it to 120 Nm torque.
  25. NISSAN QASHQAI 2.0 dCi Allrad Brake Pads replacement: online guides and video tutorials
    Step 25
    Remove the jacks and chocks.
    Replacement: brake pads – Nissan Qashqai J10. Tip from AUTODOC experts:
    Check the brake fluid level in the expansion tank and refill if necessary.
  26. Replacing Brake Pads on Nissan Qashqai j10 2008 1.5 dCi by yourself
    Step 26
    Tighten the brake fluid reservoir cap.
    AUTODOC recommends:
    Nissan Qashqai J10 – Press the brake pedal several times with the engine shut down until you feel the resistance built up.
  27. Qashqai / Qashqai +2 I (J10, NJ10) 1.6 dCi 2009 Brake Pads DIY replacement workshop manual
    Step 27
    Close the hood.
    Replacement: brake pads – Nissan Qashqai J10. AUTODOC recommends:
    Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
NISSAN Qashqai / Qashqai +2 I (J10, NJ10) Brake Pads replace by yourself - Scan QR-code and download AUTODOC CLUB app
Scan

To download the app:

  • - scan the QR code
  • - download from App Store
  • - download from Google Play
DIY NISSAN Qashqai / Qashqai +2 I (J10, NJ10) Brake Pads replacement - online guide
Tips & tricks for your NISSAN Qashqai / Qashqai +2 I (J10, NJ10)
View more
  • How to change Brake pad set on NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 1.6 - replacement tricks
    What if your car's hood won't open? | AUTODOC TIPS
  • Changing Disk pads Nissan Qashqai j10 1.5 dCi - Replacement Tips
    Replacing your engine cooling fan | AUTODOC tips
  • Maintenance Hacks - NISSAN Qashqai / Qashqai +2 I (J10, NJ10) 2.0 dCi Allrad Brake pad set disc brake replacement guide
    Headlight Restoration | AUTODOC tips
  • Replace Disk brake pads on Nissan Qashqai j10 - free video tips
    4 EASY LIFE HACKS FOR MOTORISTS | AUTODOC