Recommended replacement interval for the part category Handbrake cable : 40000 km

Important!

This replacement procedure can be used for:
RENAULT MASTER II Platform/Chassis (ED/HD/UD) 2.5 dCi, RENAULT MASTER II Platform/Chassis (ED/HD/UD) 2.2 dCI, RENAULT MASTER II Platform/Chassis (ED/HD/UD) 2.8 dTI, RENAULT MASTER II Platform/Chassis (ED/HD/UD) 2.5 D … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

Alternative products

Handbrake cable

Replacement: hand brake cable – RENAULT MASTER II Platform/Chassis (ED/HD/UD). List of the tools you'll need:

                      Wire brush
                    
                      WD-40 spray
                    
                      All-purpose cleaning spray
                    
                      Ceramic grease
                    
                      Torque wrench
                    
                      6 mm combination spanner
                    
                      13 mm combination spanner
                    
                      10 mm socket
                    
                      24 mm wheel impact socket
                    
                      Ratchet wrench or power tool for removal/installation of threaded fasteners
                    
                      Tommy bar
                    
                      Mounting lever
                    
                      Cutting pliers
                    
                      Combination pliers
                    
                      Car lift or jack with jack stands, and wheel chocks

Buy tools

Replacement: hand brake cable – RENAULT MASTER II Platform/Chassis (ED/HD/UD). AUTODOC recommends:

Replace both handbrake cables.
All the work should be carried out with the engine switched off.

Replacement: hand brake cable – RENAULT MASTER II Platform/Chassis (ED/HD/UD). Take the following steps:

Step 1

If you are going to use a jack, secure the wheels with chocks.
Step 2

Loosen the wheel fasteners. Use a 24 mm wheel impact socket. Use a tommy bar.
Step 3

Raise the vehicle.

Warning!
If you are using a jack, make sure the car is parked on a hard, flat surface.Make sure to additionally secure the car with jack stands.
Step 4

Unscrew the wheel fasteners.

Replacement: hand brake cable – RENAULT MASTER II Platform/Chassis (ED/HD/UD). Tip from AUTODOC experts:
To avoid injury, hold up the wheel when screwing in the fasteners.
Step 5

Remove the wheel.
Step 6

Fully release the handbrake.
Step 7

Clean the handbrake cable equaliser. Use a wire brush. Use WD-40 spray.
Step 8

Loosen the handbrake cable adjustment nut. Use a 6 mm combination spanner. Use a 13 mm combination spanner.
Step 9

Disconnect the handbrake cable from the equaliser bar.
Step 10

Disconnect the parts securing the handbrake cable to the car body. Use a mounting lever.
Step 11

Clean the fastener that connects the handbrake cable clamp to the bracket on the car body. Use a wire brush. Use an all-purpose cleaning spray.
Step 12

Unscrew the handbrake cable clamp fastener. Use a 10 mm socket. Use a ratchet wrench.
Step 13

Remove the fastening bolt.
Step 14

Detach the handbrake cable from the car body. Use cutting pliers.
Step 15

Remove the U-clip securing the handbrake cable to the brake caliper. Use combination pliers.
Step 16

Detach the handbrake cable from the brake caliper.
Step 17

Clean the handbrake cable mounting seats. Use a wire brush. Use an all-purpose cleaning spray.
Step 18

Install a new handbrake cable.
Step 19

Attach the handbrake cable to the brake caliper.
Step 20

Install the U-clip securing the handbrake cable to the brake caliper. Use combination pliers.
Step 21

Install the fastening bolt.
Step 22

Screw in the handbrake cable clamp fastener. Use a 10 mm socket. Use a ratchet wrench.
Step 23

Secure the handbrake cable to the car body.
Step 24

Connect the handbrake cable to the equaliser bar.
Step 25

Adjust the tension of the handbrake cables using the adjustment nut. Use a 6 mm combination spanner. Use a 13 mm combination spanner.
Step 26

Clean the wheel rim mounting seat. Use a wire brush. Use an all-purpose cleaning spray.
Step 27

Treat the brake disc surface that contacts the wheel rim. Use ceramic grease.
Step 28

Install the wheel.

Replacement: hand brake cable – RENAULT MASTER II Platform/Chassis (ED/HD/UD). AUTODOC experts recommend:
To avoid injury, hold up the wheel when screwing in the fasteners.
Step 29

Screw in the wheel fasteners. Use a 24 mm wheel impact socket. Use a ratchet wrench.
Step 30

Check that the new component is working.
Step 31

Lower the car and tighten the wheel fasteners in a criss-cross pattern. Use a 24 mm wheel impact socket. Use a torque wrench. Tightening torque: 172 N·m.
Step 32

Remove the jack and wheel chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

Need New Tyres?

Find out which tyre and wheel sizes are compatible with the RENAULT Master II Platform/Chassis model

Renault Master 2 Platform tyre size

How to change front ABS sensor on RENAULT Master II Platform/Chassis – replacement guide

Free download PDF 1.52 MB
How to change rear brake caliper on RENAULT Master II Platform/Chassis – replacement guide

Free download PDF 2.97 MB
How to change rear brake discs on RENAULT Master II Platform/Chassis – replacement guide

Free download PDF 2.24 MB
How to change rear brake pads on RENAULT Master II Platform/Chassis – replacement guide

Free download PDF 1.5 MB
How to change front brake discs on RENAULT Master II Platform/Chassis – replacement guide

Free download PDF 2.57 MB
How to change front brake pads on RENAULT Master II Platform/Chassis – replacement guide

Free download PDF 1.79 MB

How to change hand brake cable on Renault Master 2 van – replacement guide

Free download PDF 1.87 MB
How to change hand brake cable on RENAULT Master II Minibus – replacement guide

Free download PDF 1.78 MB
How to change hand brake cable on a car – replacement tutorial

Universal

Free download PDF 1.51 MB
How to change rear brake discs on Mercedes W124 – replacement guide

Free download PDF 2.2 MB
How to change hand brake cable on Mercedes W124 – replacement guide

Free download PDF 3.16 MB
How to change handbrake shoe on Mercedes W201 – replacement guide

Free download PDF 2.63 MB

Unlock your car maintenance assistant!

Track expenses, manage logs, schedule replacements, and more.

Understanding Airbag Light Warnings | Essential Tips for Car Safety

6K views

Published on: 10/04/2023
Prevent Engine Damage: How to Identify Rocker Cover Gasket Issues and Proper Replacement | AUTODOC

7K views

Published on: 03/12/2020
Top 5 mistakes when replacing spark plugs | AUTODOC tips

46K views

Published on: 13/07/2023
5 signs of a faulty strut mount and how to fix it

18K views

Published on: 28/08/2025