Important!

This replacement procedure can be used for:
AUDI TT Coupe (8J3) 2.0 TTS quattro, AUDI TT Coupe (8J3) 2.0 TDI quattro, AUDI TT Coupe (8J3) 1.8 TFSI, AUDI TT Coupe (8J3) 2.0 TTS quattro, AUDI TT Coupe (8J3) 3.2 V6 quattro, AUDI TT Coupe (8J3) 2.0 TFSI … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Control Arm for TT Coupe (8J3) and other AUDI models

Suspension arm

Link Set, wheel suspension

Rod / Strut, wheel suspension

        Suspension arm for AUDI TT Coupe (8J3) 2.0 TFSI Petrol (200 hp)
      
        Suspension arm for AUDI TT Coupe (8J3) 3.2 V6 quattro Petrol (250 hp)
      
        Suspension arm for AUDI TT Coupe (8J3) 2.0 TTS quattro Petrol (272 hp)
      
        Suspension arm for AUDI TT Coupe (8J3) 1.8 TFSI Petrol (160 hp)
      
        Suspension arm for AUDI TT Coupe (8J3) 2.0 TDI quattro Diesel (170 hp)
      
        Suspension arm for AUDI TT Coupe (8J3) 2.0 TTS quattro Petrol (265 hp)

Replacement: front lower arm – AUDI TT (8J3). Tools you might need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner 
                      
                        Copper grease 
                      
                        Drive socket # 16 
                      
                        Drive socket # 18 
                      
                        Torx bit T25
                      
                        Wheel impact socket #17
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Crow bar
                      
                        Tap wrench
                      
                        Rubber mallet
                      
                        Hydraulic transmission jack
                      
                        Wheel chock

Buy tools

Replacement: front lower arm – AUDI TT (8J3). AUTODOC recommends:

The replacement procedure is identical for the left and right lower control arms.
All work should be done with the engine stopped.

Replacement: front lower arm – AUDI TT (8J3). Take the following steps:

Step 1

Secure the wheels with chocks.
Step 2

Loosen the wheel mounting bolts. Use wheel impact socket #17.
Step 3

Raise the front of the car and secure on supports.

Step 4

Unscrew the wheel bolts.

Replacement: front lower arm – AUDI TT (8J3). Tip:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 5

Remove the wheel.
Step 6

Undo the fasteners of the oil pan lower cover. Use Torx T25.
Step 7

Remove the oil pan cover.
Step 8

Clean all joints of the arm. Use a wire brush. Use WD-40 spray.

AUTODOC recommends:
Replacement: front lower arm – AUDI TT (8J3). After applying the spray, wait a few minutes.Wear protective goggles.
Step 9

Unscrew the rear fastener connecting the control arm to the subframe. Use a drive socket #16. Use a tap wrench.
Step 10

Unscrew the rear fastener connecting the control arm to the car body. Use a drive socket #18. Use a tap wrench.
Step 11

Unscrew the front arm fastener. Use a drive socket #18. Use a tap wrench.
Step 12

Remove the fastening bolts. Use a drive socket #18. Use a drive socket #16.
Step 13

Unscrew the fastener connecting the ball joint to the suspension control arm. Use a drive socket #16. Use a tap wrench.
Step 14

Remove the fastening bolt. Use a drive socket #18.
Step 15

Disconnect the spherical joint from the arm. Use a crowbar.

Step 16

Remove the arm. Use a crowbar.
Step 17

Clean the mounting seats and the thread of the suspension arm. Use a wire brush. Use WD-40 spray.
Step 18

Install a new arm. Use a rubber mallet.

Replacement: front lower arm – AUDI TT (8J3). AUTODOC experts recommend:
During the installation process, use only new bolts and nuts.Do not damage the ball joint cover.
Step 19

Install the fastening bolt. Use a drive socket #18.
Step 20

Attach the ball joint to the control arm.

Step 21

Install the fastening bolts. Use a crowbar.
Step 22

Screw the rear fastener connecting the control arm to the car body. Use a drive socket #18. Use a ratchet wrench.
Step 23

Screw the rear fastener connecting the control arm to the subframe. Use a drive socket #16. Use a ratchet wrench.
Step 24

Screw the fasteners of the ball joint. Use a drive socket #16. Use a ratchet wrench.
Step 25

Tighten the ball joint fastener. Use a drive socket #16. Use a torque wrench. Tighten it to 60 nm torque.
Step 26

Support the arm. Use a hydraulic transmission jack.
Step 27

Tighten the front fastener connecting the control arm to the subframe. Use a drive socket #18. Use a torque wrench. Tighten it to 70 Nm torque.+180°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 28

Tighten the rear fastener connecting the arm to the car body. Use a drive socket #18. Use a torque wrench. Tighten it to 70 Nm torque.+90°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 29

Tighten the rear fastener connecting the arm to the body subframe. Use a drive socket #16. Use a torque wrench. Tighten it to 50 Nm torque.+90°

AUTODOC recommends:
Important! Be sure to use new fasteners.
Step 30

Remove the support from under the arm.

AUTODOC recommends:
AUDI TT (8J3) – Do not lower the transmission jack sharply to avoid damaging components and mechanisms of the car.
Step 31

Treat all joints of the arm. Use copper grease.
Step 32

Reinstall the oil pan lower cover.
Step 33

Tighten the fasteners of the oil pan lower cover. Use Torx T25.
Step 34

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 35

Clean the brake disk surface. Use a brake cleaner.

Replacement: front lower arm – AUDI TT (8J3). Tip from AUTODOC:
After applying the spray, wait a few minutes.
Step 36

Install the wheel.

AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. AUDI TT (8J3)
Step 37

Screw in the wheel bolts. Use wheel impact socket #17.
Step 38

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 120 nm torque.
Step 39

Remove the jacks and chocks.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change rear strut mount on AUDI TT Coupe (8J3) – replacement guide

Free download PDF
1.68 MB
How to change rear suspension lower trailing arm on AUDI TT Coupe (8J3) – replacement guide

Free download PDF
1.66 MB
How to change rear suspension lower control arm on AUDI TT Coupe (8J3) – replacement guide

Free download PDF
1.62 MB
How to change front strut mount on AUDI TT Coupe (8J3) – replacement guide

Free download PDF
3.86 MB
How to change rear anti roll bar links on AUDI TT Coupe (8J3) – replacement guide

Free download PDF
1.37 MB
How to change rear wheel bearing on AUDI TT Coupe (8J3) – replacement guide

Free download PDF
2.22 MB

How to change rear suspension lower control arm on AUDI TT Coupe (8J3) – replacement guide

Free download PDF
1.62 MB
How to change rear suspension lower trailing arm on AUDI TT Coupe (8J3) – replacement guide

Free download PDF
1.66 MB
How to change rear suspension lower control arm on AUDI TT Roadster (8J9) – replacement guide

Free download PDF
1.62 MB
How to change rear suspension lower trailing arm on AUDI TT Roadster (8J9) – replacement guide

Free download PDF
1.66 MB
How to change front lower arm on AUDI TT Roadster (8J9) – replacement guide

Free download PDF
2.1 MB
How to change control arm on a car – replacement tutorial

Universal

Free download PDF
1.07 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

Headlight Restoration | AUTODOC tips

8K views

Published on: 13/01/2021
Causes of a worn car boot damper | AUTODOC

3K views

Published on: 04/07/2021
What to do if your car heater isn't working | AUTODOC tips

4K views

Published on: 11/02/2021
How to repair a chipped or cracked windscreen | AUTODOC tips

7K views

Published on: 14/12/2023