Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
FORD STREET KA (RL2) 1.6 … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for STREET KA (RL2) and other FORD models

Brake pad set

Brake pad set for FORD STREET KA (RL2) 1.6 Petrol (95 hp)

Replacement: brake pads – FORD STREET KA (RL2). Tools you might need:

                        Wire brush
                      
                        WD-40 spray
                      
                        Brake cleaner 
                      
                        Anti-squeal paste
                      
                        Copper grease 
                      
                        HEX bit No.H7.
                      
                        Wheel impact socket #19
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Brake caliper wind back tool
                      
                        Crow bar
                      
                        Wheel chock

Buy tools

Replacement: brake pads – FORD STREET KA (RL2). Tip from AUTODOC:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
Warning! Shut down the engine before starting any work – FORD STREET KA (RL2).

Carry out replacement in the following order:

Step 1

Open the hood. Unscrew the brake fluid reservoir cap.
Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #19.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

Replacement: brake pads – FORD STREET KA (RL2). AUTODOC recommends:
To avoid injury, hold up the wheel when unscrewing the bolts.
Step 6

Remove the wheel.
Step 7

Spread the brake pads. Use a crowbar.
Step 8

Remove the dust boot caps of the brake caliper guide pins. Use a crowbar.
Step 9

Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
Step 10

Detach the brake caliper retaining spring. Use a crowbar.
Step 11

Remove the brake caliper.

Replacement: brake pads – FORD STREET KA (RL2). Tip:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur. Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary.
Step 12

Remove the brake pads.

Replacement: brake pads – FORD STREET KA (RL2). Tip from AUTODOC:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 13

Treat the brake caliper piston. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – FORD STREET KA (RL2). After applying the spray, wait a few minutes.
Step 14

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 15

Clean the brake caliper bracket from dirt and dust. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
After applying the spray, wait a few minutes.
Step 16

Treat the brake pads in the area where their surface comes into contact with the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – FORD STREET KA (RL2). AUTODOC recommends:
Make sure the disc surface is clean before installing the pads.
Step 17

Install new brake pads.

Replacement: brake pads – FORD STREET KA (RL2). Tip from AUTODOC experts:
Make sure the pads are installed with linings facing the disc.
Step 18

Install the brake caliper and fix it. Use HEX No.H7. Use a torque wrench. Tighten it to 30 Nm torque.
Step 19

Install the dust boot caps of the brake caliper guide pins.
Step 20

Install the brake caliper retaining spring.
Step 21

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 22

Clean the brake disk surface. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – FORD STREET KA (RL2). After applying the spray, wait a few minutes.
Step 23

Install the wheel.

Replacement: brake pads – FORD STREET KA (RL2). Tip from AUTODOC experts:
To avoid injury, hold up the wheel when screwing in the fastening bolts.
Step 24

Screw in the wheel bolts. Use wheel impact socket #19.
Step 25

Lower the car and working in a cross order, tighten the wheel bolts. Use wheel impact socket #19. Use a torque wrench. Tighten it to 95 Nm torque.

AUTODOC recommends:
Important! Replacement: brake pads – FORD STREET KA (RL2). Check the brake fluid level in the reservoir and top up if necessary.
Step 26

Tighten the brake fluid reservoir cap.

AUTODOC recommends:
FORD STREET KA (RL2) – Without starting the engine, press the brake pedal several times until it feels firm.
Step 27

Close the hood.

Step 28

Remove the jacks and chocks.

Replacement: brake pads – FORD STREET KA (RL2). Professionals recommend:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change front brake discs on FORD STREET KA (RL2) – replacement guide

Free download PDF
1.8 MB
How to change spark plugs on FORD STREET KA (RL2) – replacement guide

Free download PDF
931.84 KB
How to change front windshield wipers on FORD STREET KA (RL2) – replacement guide

Free download PDF
665.6 KB
How to change front anti roll bar links on FORD STREET KA (RL2) – replacement guide

Free download PDF
1.27 MB
How to change water pump & timing belt kit on Ford Fiesta JA8 – replacement guide

Free download PDF
7.83 MB
How to change serpentine belt on Ford Fiesta V JH JD – replacement guide

Free download PDF
2.14 MB

How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB
How to change rear brake pads on Ford Focus MK2 – replacement guide

Free download PDF
1.81 MB
How to change front brake pads on Ford Focus MK2 – replacement guide

Free download PDF
2.37 MB
How to change front brake pads on Ford Fiesta JA8 – replacement guide

Free download PDF
1.61 MB
How to change front brake pads on Ford Fiesta V JH JD – replacement guide

Free download PDF
1.74 MB
How to change front brake pads on Ford Focus DAW – replacement guide

Free download PDF
1.79 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

How to start a car after a long idle period | AUTODOC tips

6K views

Published on: 20/05/2021
Causes of a worn car boot damper | AUTODOC

3K views

Published on: 04/07/2021
Top 5 mistakes when replacing spark plugs | AUTODOC tips

9K views

Published on: 13/07/2023
How to repair a chipped or cracked windscreen | AUTODOC tips

7K views

Published on: 14/12/2023