Recommended replacement interval for the part category Brake pad set : 30000 km

Important!

This replacement procedure can be used for:
FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 Ti, FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 Ti, FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 EcoBoost, FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 EcoBoost, FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 TDCi, FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 TDCi, FORD C-Max II (DXA/CB7, DXA/CEU) 2.0 TDCi, FORD C-Max II (DXA/CB7, DXA/CEU) 2.0 TDCi, FORD C-Max II (DXA/CB7, DXA/CEU) 2.0 TDCi, FORD C-Max II (DXA/CB7, DXA/CEU) 2.0 TDCi, FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 Flexifuel, FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 Ti, FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 LPG, FORD C-Max II (DXA/CB7, DXA/CEU) 1.0 EcoBoost, FORD C-Max II (DXA/CB7, DXA/CEU) 1.0 EcoBoost, FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 LPG, FORD C-Max II (DXA/CB7, DXA/CEU) 1.5 EcoBoost, FORD C-Max II (DXA/CB7, DXA/CEU) 1.5 EcoBoost, FORD C-Max II (DXA/CB7, DXA/CEU) 1.5 TDCi, FORD C-Max II (DXA/CB7, DXA/CEU) 1.5 TDCi ECOnetic, FORD C-Max II (DXA/CB7, DXA/CEU) 1.5 TDCi, FORD C-Max II (DXA/CB7, DXA/CEU) 2.0 TDCi, FORD C-Max II (DXA/CB7, DXA/CEU) 2.0 TDCi, FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 Ti, FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 CNG … View more

The steps may slightly vary depending on the car design.

This video shows the replacement procedure of a similar car part on another vehicle

All the parts you need to replace – Brake Pads for C-Max II (DXA/CB7, DXA/CEU) and other FORD models

Brake pad set

        Brake pad set for FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 Ti Petrol (125 hp)
      
        Brake pad set for FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 Ti Petrol (105 hp)
      
        Brake pad set for FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 EcoBoost Petrol (150 hp)
      
        Brake pad set for FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 EcoBoost Petrol (182 hp)
      
        Brake pad set for FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 TDCi Diesel (95 hp)
      
        Brake pad set for FORD C-Max II (DXA/CB7, DXA/CEU) 1.6 TDCi Diesel (115 hp)
      
        Brake pad set for FORD C-Max II (DXA/CB7, DXA/CEU) 2.0 TDCi Diesel (163 hp)
      
        Brake pad set for FORD C-Max II (DXA/CB7, DXA/CEU) 2.0 TDCi Diesel (115 hp)
      
        Brake pad set for FORD C-Max II (DXA/CB7, DXA/CEU) 2.0 TDCi Diesel (140 hp)

Replacement: brake pads – FORD C-MAX II. List of the tools you'll need:

                        Wire brush
                      
                        Brake cleaner 
                      
                        Anti-squeal paste
                      
                        Copper grease 
                      
                        HEX bit No.H7.
                      
                        Wheel impact socket #19
                      
                        Ratchet wrench
                      
                        Torque wrench
                      
                        Brake caliper wind back tool
                      
                        Crow bar
                      
                        Wheel chock

Buy tools

Replacement: brake pads – FORD C-MAX II. AUTODOC experts recommend:

Perform the replacement of brake pads in complete set for each axis. This provides effective braking.
The replacement procedure is identical for all brake pads on the same axle.
All work should be done with the engine stopped.

Replacement: brake pads – FORD C-MAX II. Use the following procedure:

Step 1

Open the bonnet. Unscrew the brake fluid reservoir cap.

Step 2

Secure the wheels with chocks.
Step 3

Loosen the wheel mounting bolts. Use wheel impact socket #19.
Step 4

Raise the front of the car and secure on supports.

Step 5

Unscrew the wheel bolts.

AUTODOC recommends:
Warning! To avoid injury, hold the wheel while unscrewing the fastening bolts. FORD C-MAX II
Step 6

Remove the wheel.
Step 7

Spread the brake pads. Use a crowbar.
Step 8

Detach the brake caliper retaining spring. Use a crowbar.
Step 9

Remove the dust boot caps of the brake caliper guide pins.
Step 10

Unscrew the brake caliper fastening. Use HEX No.H7. Use a ratchet wrench.
Step 11

Remove the brake caliper.

Replacement: brake pads – FORD C-MAX II. AUTODOC recommends:
Tie the caliper to the suspension or to the body with a wire without disconnecting from the brake hose to prevent depressurization of the brake system.Make sure that the brake caliper is not hanging on the brake hose.Don't press the brake pedal after the brake caliper has been removed. As a result, the piston can fall out from the brake cylinder, and brake fluid leakage and depressurization of the system may occur.
Step 12

Remove the brake pads.

Replacement: brake pads – FORD C-MAX II. Tip:
Measure the brake disc thickness. Upon reaching the wear limit the part must be replaced.
Step 13

Press in the brake caliper piston. Use brake caliper wind back tool.
Step 14

Check the brake caliper bracket, brake caliper guide pins and boots. Clean them. Replace, if necessary. Use a wire brush. Use a brake cleaner.

AUTODOC recommends:
Replacement: brake pads – FORD C-MAX II. After applying the spray, wait a few minutes.
Step 15

Treat the back side of the new brake pads. Treat the brake caliper bracket. Use anti-squeal paste.

Replacement: brake pads – FORD C-MAX II. Tip from AUTODOC:
Make sure the disc surface is clean before installing the pads.
Step 16

Install new brake pads.

Replacement: brake pads – FORD C-MAX II. Professionals recommend:
Make sure the pads are installed with linings facing the disc.
Step 17

Install the brake caliper and fix it. Use HEX No.H7. Use a torque wrench. Tighten it to 28 Nm torque.
Step 18

Install the dust boot caps of the brake caliper guide pins.
Step 19

Install the brake caliper retaining spring.

Replacement: brake pads – FORD C-MAX II. Tip from AUTODOC experts:
Without starting the engine, press the brake pedal several times until you feel significant resistance.
Step 20

Treat the surface where the brake disc contacts the wheel rim. Use copper grease.
Step 21

Install the wheel.

AUTODOC recommends:
Important! Hold the wheel while screwing in the fastening bolts. FORD C-MAX II
Step 22

Screw in the wheel bolts. Use wheel impact socket #19.
Step 23

Lower the car and working in a cross order, tighten the wheel bolts. Use a torque wrench. Tighten it to 110 nm torque.
Step 24

Remove the jacks and chocks.

AUTODOC recommends:
Important! Replacement: brake pads – FORD C-MAX II. Check the brake fluid level in the reservoir and top up if necessary.
Step 25

Tighten the brake fluid reservoir cap. Close the hood.

Replacement: brake pads – FORD C-MAX II. AUTODOC recommends:
Slow down smoothly for first 150-200 km after the brake pads replacement. Avoid unneccessary and sharp braking to a stop.

Was this manual helpful?

Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.

How to change front brake caliper on FORD C-Max II (DXA/CB7, DXA/CEU) – replacement guide

Free download PDF
2.12 MB
How to change rear brake pads on FORD C-Max II (DXA/CB7, DXA/CEU) – replacement guide

Free download PDF
1.72 MB
How to change serpentine belt on FORD C-Max II (DXA/CB7, DXA/CEU) – replacement guide

Free download PDF
768 KB
How to change spark plugs on FORD C-Max II (DXA/CB7, DXA/CEU) – replacement guide

Free download PDF
942.08 KB
How to change engine oil and filter on FORD C-Max II (DXA/CB7, DXA/CEU) – replacement guide

Free download PDF
2.42 MB
How to change fuel filter on FORD C-Max II (DXA/CB7, DXA/CEU) – replacement guide

Free download PDF
1.66 MB

How to change front brake pads on FORD Grand C-Max (DXA/CB7, DXA/CEU) – replacement guide

Free download PDF
2.36 MB
How to change rear brake pads on FORD Grand C-Max (DXA/CB7, DXA/CEU) – replacement guide

Free download PDF
1.72 MB
How to change rear brake pads on FORD C-Max II (DXA/CB7, DXA/CEU) – replacement guide

Free download PDF
1.72 MB
How to change front brake pads on FORD C-Max (DM2) – replacement guide

Free download PDF
2.35 MB
How to change rear brake pads on FORD C-MAX (DM2) – replacement guide

Free download PDF
1.72 MB
How to change brake pads on a car – replacement tutorial

Universal

Free download PDF
2.84 MB

Your profile is your personal assistant.

It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents

Install the AUTODOC CLUB app!

Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.

Scan

To download the app:

- scan the QR code
- download from App Store
- download from Google Play

5 car tips for a winter's day | AUTODOC tips

5K views

Published on: 05/02/2024
What to do if your check engine light is on | AUTODOC tips

15K views

Published on: 19/08/2020
Top 5 mistakes when replacing spark plugs | AUTODOC tips

9K views

Published on: 13/07/2023
TOP 6 WD-40 lifehacks | AUTODOC tips

12K views

Published on: 15/07/2021