
How to change engine oil and filter on MITSUBISHI Pajero / Shogun Sport II Off-Road (KH, KG) – replacement guide
MITSUBISHI PAJERO SPORT II (KH_, KG_) 2.5 DI-D, MITSUBISHI PAJERO SPORT II (KH_, KG_) 2.5 DI-D 4WD (KG4W), MITSUBISHI PAJERO SPORT II (KH_, KG_) 2.5 DI-D 4WD (KH4W), MITSUBISHI PAJERO SPORT II (KH_, KG_) 2.5 DI-D (KH4WG) … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle

- Replace the oil filter every time you change the engine oil.
- Before getting down to work, warm up the engine to reduce the viscosity of the oil.
- Wear gloves to prevent contact with hot liquid.
- Please note: all work on the car – MITSUBISHI PAJERO SPORT II (KH_, KG_) – should be done with the engine switched off.
- Step 1
Open the bonnet.
Step 2Use a fender protection cover to avoid damaging the paintwork and plastic parts of the car.
Step 3
Unscrew the oil filler cap.
- Step 4

Pull up the oil dipstick.
- Step 5
Lift the vehicle using a vehicle lift or place it over an inspection pit.
Replacement: engine oil and filter – MITSUBISHI PAJERO SPORT II (KH_, KG_). Tip from AUTODOC experts:The vehicle must be level, but if it is at an angle, the drain plug must be at the lowest point.
Step 6
Put an oil drain pan with a capacity of at least 8 litres under the drain hole.
- Step 7

Clean the area of the oil pan drain hole. Use a wire brush. Use an all-purpose cleaning spray.
- Step 8

Unscrew the drain plug. Use a 17 mm socket. Use a ratchet wrench.
- Step 9

Drain the used oil.
Caution!The oil may be hot.Wait until the oil has completely flowed out of the drain hole.
- Step 10

Turn the wheels fully to the right.
- Step 11

Unscrew the oil filter. Use a 100-15F cup type oil filter wrench. Use a ratchet wrench.
- Step 12

Remove the oil filter.
- Step 13

Clean the oil filter mounting seat. Use an all-purpose cleaning spray.
- Step 14
Apply a small amount of fresh oil to the new filter's gasket.
Step 15
Install the new oil filter.
- Step 16

Tighten the oil filter. Use a 100-15F cup type oil filter wrench. Use a torque wrench. Tightening torque: 22 N·m.
- Step 17

Clean the area of the oil pan drain hole. Use an all-purpose cleaning spray.
Find out which tyre and wheel sizes are compatible with the MITSUBISHI Pajero / Shogun Sport II Off-Road (KH, KG) model
Popular maintenance tutorials for MITSUBISHI PAJERO SPORT II (KH_, KG_)
Complete guides for changing the Oil filters on different MITSUBISHI PAJERO / SHOGUN SPORT models
Track expenses, manage logs, schedule replacements, and more.
Top 5 Car Interior Cleaning Mistakes You Should Avoid | AUTODOC Tips
Transform Your Car's Look: 6 Simple Accessories You Need to Try!
Checking the starter without removing it | AUTODOC tips
Why Is the Windscreen Washer Not Spraying? Solution
Most commonly replaced car parts on MITSUBISHI PAJERO / SHOGUN SPORT
Professional manuals for the most common MITSUBISHI models
































