Disclaimer
How to change engine oil and filter on HONDA Civic XI Hatchback (FL) – replacement guide
downloads:
0
Views:
0
Recommended replacement interval for the part category Oil filter : 12 month / 15000 km
Important!
This replacement procedure can be used for:
HONDA Civic XI Hatchback (FL) 2.0 e:HEV, HONDA Civic XI Hatchback (FL) Type-R … View more
The steps may slightly vary depending on the car design.
HONDA Civic XI Hatchback (FL) 2.0 e:HEV, HONDA Civic XI Hatchback (FL) Type-R … View more
The steps may slightly vary depending on the car design.
This video shows the replacement procedure of a similar car part on another vehicle
All the parts you need to replace – Oil Filter for Civic XI Hatchback (FL) and other HONDA models
Oil filter
Alternative products
Oil filter
Wire brush
All-purpose cleaning spray
Torque wrench
Drive socket # 17
Oil filter cup socket 65/14-F
Ratchet wrench
Funnel
Oil drain pan
Replacement: engine oil and filter – HONDA Civic XI Schrägheck (FL). AUTODOC recommends:
- Replace the oil filter every time when changing motor oil.
- Wear gloves to prevent contact with hot liquid.
- Use only new O-rings during installation.
- Please note: all work on the car – HONDA Civic XI Schrägheck (FL) – should be done with the engine switched off.
Carry out replacement in the following order:
- Step 1Lift the car using a jack or place it over an inspection pit.Replacement: engine oil and filter – HONDA Civic XI Schrägheck (FL). AUTODOC experts recommend:The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.Unscrew the oil filler plug.Step 2
Put a waste oil container with at least 4 l capacity under the drainage hole. - Step 3
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray. - Step 4
Unscrew the drain plug. Use a drive socket #17. Use a ratchet wrench. - Step 5
Drain the used oil.AUTODOC recommends:Caution! The oil may be hot.Wait until the oil has completely drained from the drainage hole. - Step 6
Clean the area of the oil pan drainage hole. - Step 7
Screw in the new drainage plug and tighten it. Use a drive socket #17. Use a torque wrench. Tighten it to 39 nm torque. - Step 8
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray. - Step 9
Unscrew the oil filter. Use the 65/14-F socket. Use a ratchet wrench. - Step 10Put the old oil filter in the container.Step 11
Clean the oil filter seat. Use all-purpose cleaning spray. - Step 12
Screw the new filter into its place. Use the 65/14-F socket. Observe the recommended tightening torque.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Need New Tyres?
Find out which tyre and wheel sizes are compatible with the HONDA Civic XI Hatchback (FL) model
Popular maintenance tutorials for HONDA Civic XI Schrägheck (FL)
Free download PDF
1.18 MB
Free download PDF2.1 MB
Free download PDF1.26 MB
Free download PDF1.33 MB
Free download PDF1.91 MB
Free download PDF3.1 MB
Complete guides for changing the Oil filters on different HONDA CIVIC models
- Free download PDF2.1 MB
Free download PDF1.09 MB
Free download PDF1.09 MB
Free download PDF1.09 MB
Free download PDF1.1 MB
Free download PDF1.09 MB
Unlock your car maintenance assistant!
Track expenses, manage logs, schedule replacements, and more.
Tips & tricks for your HONDA Civic XI Hatchback (FL)
View more
Unveiling the secrets: Detecting vacuum leaks with a Smoke Machine | AUTODOC
Save Money on Fuel with These Easy Tips | AUTODOC
DIY alternator repair | AUTODOC tips
Drive with Care: 8 Common Bad Driving Habits Explained | AUTODOC
Most commonly replaced car parts on HONDA CIVIC
Time to replace parts? Get even better deals in our Shop app.
SCAN ME