The vehicle must be on even keel, and if it is at an angle, the drain plug must be at the lowest point.All work should be done with the engine stopped.
Step 7
Put a waste oil container with at least 5 l capacity under the drainage hole.
Step 8
Clean the area of the oil pan drainage hole. Use a wire brush. Use all-purpose cleaning spray.
Step 9
Unscrew the drain plug. Use a drive socket #21. Use a ratchet wrench.
Wait until the oil has completely drained from the drainage hole.
Step 12
Clean the area of the oil pan drainage hole.
Step 13
Screw in the new drainage plug and tighten it. Use a drive socket #21. Use a torque wrench. Tighten it to 34 Nm torque.
Step 14
Clean the area of the oil pan drainage hole. Use all-purpose cleaning spray.
Step 15
Lower the car.
Step 16
Lubricate the rubber seal of the new filter with a little amount of fresh oil.
Step 17
Screw the new filter into its place. Use the 74/76-15F socket. Use a torque wrench. Tighten it to 25 Nm torque.
Step 18
Remove the oil filler cap. Insert the funnel.
Step 19
Pour new oil into the engine in the amount recommended by the car manufacturer.
Replacement: engine oil and filter – CITROËN JUMPY Box. Tip:
Use the oil recommended by the manufacturer.
Step 20
Check the oil level using the dipstick. Top up oil if necessary.
Please note!
The oil level should be between the Min and Max marks.
Step 21
Install the oil filler cap.
Step 22
Tighten the oil filler cap.
Step 23
Run the engine for a few minutes. After the oil pressure warning light goes out, stop the engine.
Step 24
Check the oil level 5 minutes after the stop of the engine operation using a dipstick and add oil if necessary.
Please note!
The oil level should be between the Min and Max marks.Make sure that the oil filler cap is properly tightened.Check the threaded plug of the drainage hole and the oil filter seal for tightness. If necessary, carefully tighten them up.
Step 25
Remove the fender protection cover.
Step 26
Close the hood.
Replacement: engine oil and filter – CITROËN JUMPY Box. Tip from AUTODOC experts:
Note that oil pressure warning light, which indicates insufficient pressure in the lubrication system, may be on for a longer time than usual. After a few seconds, the oil will fill all the channels, and the light will go out. To protect the environment from pollution, be sure to dispose of the used filters at special collection points.
Was this manual helpful?
Please rate this manual on a scale from 1 to 5. If you have any questions, feel free to ask us.
Users voted – 0
Popular maintenance tutorials for CITROËN JUMPY Box
It can track car expenses, keep a car log and replacement schedule, and save favourite materials, notes and documents
Install the AUTODOC CLUB app!
Your personal car expenses manager, maintenance tips, reminders about upcoming appointments and service intervals, DIY repair instructions – all this on your phone.
Scan
To download the app:
- scan the QR code
- download from App Store
- download from Google Play
Tips & tricks for your CITROËN Jumpy Van (V_)
View more
How to shine your tyres | AUTODOC tips
5 common car washing mistakes | AUTODOC tips
Top 5 reasons why your car squeals | AUTODOC Tips
How and why to check your oil | AUTODOC tips
Most commonly replaced car parts on CITROËN DISPATCH